Search results
Results from the WOW.Com Content Network
Serrated face nut. A serrated face nut is a locknut with ridges on the face of the nut that bite into the surface it is tightened against. The serrations are angled such that they keep the nut from rotating in the direction that would loosen the nut. Due to the serrations they cannot be used with a washer or on surfaces that cannot be scratched ...
Keps nut (K-nut or washer nut) with a free-spinning washer. In the locknut form, this is a star-type lock washer. Plate nut; Polymer insert nut ; Security locknut All steel reusable nut for high vibration and harsh environments. Serrated face nut; Serrated flange nut; Speed nut (sheet metal nut or Tinnerman nut) Split beam nut (BINX nut [5])
Serrated flange nuts. A flange nut is a nut that has a wide flange at one end that acts as an integrated washer.This serves to distribute the pressure of the nut over the part being secured, reducing the chance of damage to the part and making it less likely to loosen as a result of an uneven fastening surface.
Fasteners commonly used with piping are a stud bolt [25] with nuts (usually fully threaded, with two heavy, hexagonal nuts); a machine bolt and nut; or a powder-actuated tool (PAT) fastener (usually a nail or threaded stud, driven into concrete or masonry).
Prevailing torque type hexagon nuts with flange and with non-metallic insert: Withdrawn: DIN EN 1663, DIN EN 1666: ISO 7043 (modified), ISO 12125 (modified) DIN 6927: Prevailing torque type all-metal nuts with flange: Withdrawn: DIN EN 1664, DIN EN 1667: ISO 7044 (modified), ISO 12126 (modified) DIN 6935: Cold bending of flat rolled steel: Active
When the fastener is tightened, the base of the nut, which is arched, elastically deforms and applies a force to the fastener, which locks it from loosening under vibrations. [1] There are many different types of speed nuts, mostly dependent on the shape of the nut, how it attaches to the workpiece, and what type of screw can be used.
The screw itself should be drilled a minimum of 1" into the concrete to hold effectively and a maximum of 1-3/4" or the threads will wear and will lose holding power. Ideally 1-1/4" to 1-1/2" of screw thread in the concrete. [1] So for example, if a 1/2" board is being screwed onto the concrete, a 1-3/4" to 2" concrete screw should be used ...
Standard nut employed as a jam nut against another standard nut. A jam nut is a low profile type of nut, typically half as tall as a standard nut. It is commonly used as a type of locknut, where it is "jammed" up against a standard nut to lock the two in place. It is also used in situations where a standard nut would not fit.