Ads
related to: connecting-rod bearing journals
Search results
Results from the WOW.Com Content Network
A crankpin or crank pin, also known as a rod bearing journal, [1] is a mechanical device in an engine which connects the crankshaft to the connecting rod for each cylinder. It has a cylindrical surface, to allow the crankpin to rotate relative to the "big end" of the connecting rod. [2] [3] [4]
The crankshaft is a rotating shaft containing one or more crankpins, [1] that are driven by the pistons via the connecting rods. [2] The crankpins are also called rod bearing journals, and they rotate within the "big end" of the connecting rods. Most modern crankshafts are located in the engine block.
A connecting rod, also called a 'con rod', [1] [2] [3] is the part of a piston engine which connects the piston to the crankshaft. Together with the crank, the connecting rod converts the reciprocating motion of the piston into the rotation of the crankshaft. [4] The connecting rod is required to transmit the compressive and tensile forces from ...
In the semi-floating configuration, the pin is usually fixed relative to the piston by an interference fit with the journal in the piston. (This replaced the earlier set screw method. [3]) The connecting rod small end bearing thus acts as the bearing alone. In this configuration, only the small end bearing requires a bearing surface, if any.
The lower half of the main bearings are typically held in place by 'bearing caps' which are secured to the engine block using bolts. The basic arrangement is for each bearing cap to have two bolts, but some engines may have four or six bolts per bearing cap (often referred to as "four-bolt mains" or "six-bolt mains" engines).
The 400 is the only engine that uses a 2.65 in (67.3 mm) main bearing journal and a 2.1 in (53.3 mm) rod bearing journal. The connecting rod was also 400 specific being 5.565 in (141.4 mm) as opposed to the 5.7 in (144.8 mm) rod used in all other small-block Chevrolet engines.
Top view section of the Cyclone Waste Heat Engine (WHE) six cylinder radial steam engine. A unique 'spider bearing' is used to connect all six connecting rods to the crankpin, rather than the traditional master connecting rod used in radial engines. Steam is exhausted through the piston tops into the crankcase.
In a flat-eight engine, the connecting rods for corresponding pistons from the left and right banks may share a crankshaft journal. A boxer-eight engine is a special case of a flat-eight where each piston's connecting rod has its own journal, and each pair of opposed pistons moves inwards or outwards at the same time.
Ads
related to: connecting-rod bearing journals