Search results
Results from the WOW.Com Content Network
A split microfiber will cling to imperfections of the skin and can be either heard or felt as it does. Alternatively, a small amount of water can be poured onto a hard, flat surface and pushed with the microfiber. If the water is pushed rather than absorbed, it is not split microfiber. [citation needed]
Unless stated otherwise, the properties of fused silica (quartz glass) and germania glass are derived from the SciGlass glass database by forming the arithmetic mean of all the experimental values from different authors (in general more than 10 independent sources for quartz glass and T g of germanium oxide glass). The list is not exhaustive.
There are two methods of applying the Low-E coating to the glazing: Hard Coat and Soft Coat. Hard Coat is applied either in or directly after the tin bath in the float glass manufacturing process. This produces a coating which is very durable and inexpensive, as it is added during the existing production process.
Self-cleaning glass is a specific type of glass with a surface that keeps itself free of dirt and grime. The field of self-cleaning coatings on glass is divided into two categories: hydrophobic and hydrophilic. These two types of coating both clean themselves through the action of water, the former by rolling droplets and the latter by sheeting ...
Paint protection films use by the military has continued to the present day and 3M now makes a wide variety of aerospace and military films. [3] With time, however, the automobile industry began to take note of the protective benefits of PPF and it was soon being employed by race car drivers despite the difficulty of working with the original films.
Silvering on the inside of a glass test tube. Silvering is the chemical process of coating a non-conductive substrate such as glass with a reflective substance, to produce a mirror. While the metal is often silver, the term is used for the application of any reflective metal.
The gelcoat (a smooth, hard polyester resin coating) is applied to the mould surface and is given time to cure before re-applying. Usually two coats of gelcoat are used. The barrier coat is applied to avoid fibre print and a rough surface through the gel coat. The barrier coat is cured in an oven and left to cool to room temperature.
Pages in category "Glass coating and surface modification" The following 23 pages are in this category, out of 23 total. This list may not reflect recent changes. A.