Ad
related to: quarter inch to 3.5mmebay.com has been visited by 1M+ users in the past month
Search results
Results from the WOW.Com Content Network
The outside diameter of the sleeve is 6.35 millimetres (1 ⁄ 4 inch) for full-sized connectors, 3.5 mm (1 ⁄ 8 in) for "mini" connectors, and only 2.5 mm (1 ⁄ 10 in) for "sub-mini" connectors. Rings are typically the same diameter as the sleeve.
This includes the original 6.35mm (quarter inch) jack and the more recent and standard 3.5mm (miniature or 1/8 inch) and 2.5mm (subminiature) jacks, both mono and stereo (balanced) versions. [2] XLR connectors, also known as Cannon plugs, used for analog or digital balanced audio with a balanced line. Digital audio interfaces and interconnects:
Photo: 2.5 mm mono (TS), 3.5 mm mono and stereo (TRS), and 1 ⁄ 4 inch (6.4 mm) stereo (TRS) phone connectors The most common microphone connector in consumer use is the venerable phone connector, in 1 ⁄ 4 inch (6.4 mm), 3.5 mm, and 2.5 mm sizes, and in both mono and stereo configurations.
8-inch floppy disk, inserted in drive, (3½-inch floppy diskette, in front, shown for scale) 3½-inch, high-density floppy diskettes with adhesive labels affixed The first commercial floppy disks, developed in the late 1960s, were 8 inches (203.2 mm) in diameter; [4] [5] they became commercially available in 1971 as a component of IBM products and both drives and disks were then sold ...
Lego trains use a fixed nominal gauge of 37.5 mm (1 + 15 ⁄ 32 in), based on 5-stud track centerlines gauge. [5] [6] [7] The 37.5 mm length is not derived by a certain scale ratio. While HO scale is a 1:87 scale (3.5 mm to 1 foot), resulting in a 16.5 mm (0.65 in) gauge from real life prototype 1,435 mm (4 ft 8 + 1 ⁄ 2 in) standard gauge ...
8-, 5.25-, 3.5-, 2.5-, 1.8- and 1-inch HDDs, together with a ruler to show the length of platters and read-write heads A newer 2.5-inch (63.5 mm) 6,495 MB HDD compared to an older 5.25-inch full-height 110 MB HDD. IBM's first hard drive, the IBM 350, used a stack of fifty 24-inch platters and was of a size comparable to two large refrigerators.
Example (inch, fine): For 7 ⁄ 16-20 (same diameter as the previous example, but this time with 20 threads per inch, which is considered fine), 0.437 in × 0.90 = 0.393 in (i.e., if the threads are to be fine, then a slightly larger diameter drill bit should be used before tapping the hole for the screw).
Julienne; referred to as the allumette (or matchstick) when used on potatoes, the julienne measures approximately 1 ⁄ 8 by 1 ⁄ 8 by 1–2 inches (0.3 cm × 0.3 cm × 3 cm–5 cm). It is also the starting point for the brunoise cut.
Ad
related to: quarter inch to 3.5mmebay.com has been visited by 1M+ users in the past month