enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. O-ring - Wikipedia

   en.wikipedia.org/wiki/O-ring

   Typical O-ring and application. An O-ring, also known as a packing or a toric joint, is a mechanical gasket in the shape of a torus; it is a loop of elastomer with a round cross-section, designed to be seated in a groove and compressed during assembly between two or more parts, forming a seal at the interface.

3. Hydraulic seal - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_seal

   A hydraulic seal is a relatively soft, non-metallic ring, captured in a groove or fixed in a combination of rings, forming a seal assembly, to block or separate fluid in reciprocating motion applications. Hydraulic seals are vital in machinery. Their use is critical in providing a way for fluid power to be converted to linear motion.

4. Hydraulic cylinder - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_cylinder

   A hydraulic cylinder is the actuator or "motor" side of this system. The "generator" side of the hydraulic system is the hydraulic pump which delivers a fixed or regulated flow of oil to the hydraulic cylinder, to move the piston. There are three types of pump widely used: hydraulic hand pump, hydraulic air pump, and hydraulic electric pump.

5. O-ring boss seal - Wikipedia

   en.wikipedia.org/wiki/O-ring_boss_seal

   An o-ring boss seal is a technique for joining two fluid-carrying pipes, hoses, or tubing. In an o-ring boss (abbreviated ORB) system, a male-threaded part is inserted into a female-threaded part, providing a mechanical seal. This system differs from others in that a nut is tightened over an o-ring in a chamfered area, creating a fluid-tight ...

6. Hydraulic machinery - Wikipedia

   en.wikipedia.org/wiki/Hydraulic_machinery

   The tubes are supplied by manufacturers in lengths of 6 m, cleaned, oiled and plugged. The tubes are interconnected by different types of flanges (especially for the larger sizes and pressures), welding cones/nipples (with o-ring seal), several types of flare connection and by cut-rings. In larger sizes, hydraulic pipes are used.

7. Back-up ring - Wikipedia

   en.wikipedia.org/wiki/Back-up_ring

   A back-up ring is a rigid ring that holds an elastomeric seal or plastic (such as Polyethylene) connection to its designed shape and in its correct place. Back up rings are commonly used with O-rings, lip seals, and as reciprocating shaft seals. They are also used for piping connections joining two different materials - typically one flexible ...