Ads
related to: difference between theodolite and tachometer sensor circuit tester kit free
Search results
Results from the WOW.Com Content Network
A theodolite is used to measure the horizontal angle between indicators on the two ends of the subtense bar. The distance from the telescope to the subtense bar is the height of an isosceles triangle formed with the theodolite at the upper vertex and the subtense bar length at its base, determined by trigonometry.
The difference from the traditional Rogowski coil is that the sensor can be manufactured using a planar coil rather than a toroidal coil. In order to reject the influence of conductors outside the sensor's measurement region, these planar Rogowski current sensors use a concentric coil geometry instead of a toroidal geometry to limit the ...
A theodolite (/ θ i ˈ ɒ d ə ˌ l aɪ t /) [1] is a precision optical instrument for measuring angles between designated visible points in the horizontal and vertical planes. The traditional use has been for land surveying , but it is also used extensively for building and infrastructure construction , and some specialized applications such ...
It can be used to acquire data in the testing of missiles, rockets, projectiles, aircraft, and fire control systems; in the ripple firing of rockets, graze action tests, air burst fuze tests, and similar operations. Cinetheodolites provide angular measurements of the line of sight to the vehicle.
The sensor circuit is supplied with constant current. A distinguishing feature of the IEPE principle is that the power supply and the sensor signal are transmitted via one shielded wire. Most IEPE sensors work at a constant current between 2 and 20 mA. A common value is 4 mA. The higher the constant current the longer the possible cable length.
A tachometer that can indicate up to 7000 RPM (left) A tachometer (revolution-counter, tach, rev-counter, RPM gauge) is an instrument measuring the rotation speed of a shaft or disk, as in a motor or other machine. [1] The device usually displays the revolutions per minute (RPM) on a calibrated analogue dial, but digital displays are ...
A common form of in-circuit testing uses a bed-of-nails tester.This is a fixture that uses an array of spring-loaded pins known as "pogo pins". When a printed circuit board is aligned with and pressed down onto the bed-of-nails tester, the pins make electrical contact with locations on the circuit board, allowing them to be used as test points for in-circuit testing.
More advanced current probes combine a Hall effect sensor with a current transformer. The Hall effect sensor measures the DC and low frequency components of the signal and the current transformer measures the high frequency components. These signals are combined in the amplifier circuit to yield a wide band signal extending from DC to over 50 MHz.
Ads
related to: difference between theodolite and tachometer sensor circuit tester kit free