Search results
Results from the WOW.Com Content Network
A carburetor heat system is often used to prevent icing. [35] This system consists of a secondary air intake which passes around the exhaust, in order to heat the air before it enters the carburetor. Typically, the system is operated by the pilot manually switching the intake air to travel via the heated intake path as required.
Starting with the 1986 model year, the AMC straight-4 engines used a throttle body injection (TBI) or single-point, fuel injection system with a new fully computerized engine control. [3] In addition to cycling the fuel injector (pulse-width time, on–off), the engine control computer also determined the ignition timing, idle speed, exhaust ...
The Motorcraft 2150 is a Ford (also used by AMC) 2-barrel carburetor manufactured from 1973 through 1983, [1] based heavily on its predecessor, the Autolite 2100 carburetor. The 2150 improved on the 2100s design through the introduction of a variable air bleed system, which keeps the air to fuel mixture better balanced throughout the carburetor ...
Carburetor heat (usually abbreviated to 'carb heat') is a system used in automobile and piston-powered light aircraft engines to prevent or clear carburetor icing. It consists of a moveable flap which draws hot air into the engine intake. The air is drawn from the heat stove, a metal plate around the (very hot) exhaust manifold.
Dieseling or engine run-on is a condition that can occur in spark-plug-ignited, gasoline-powered internal combustion engines, whereby the engine keeps running for a short period after being turned off, drawing fuel through the carburetor, into the engine and igniting it without a spark.
The Wheeler–Schebler Carburetor Company was one of the Indianapolis's most important auto parts manufacturers and the last automobile parts factories in Indianapolis, Indiana to survive from the first decades of the 20th century. The Wheeler–Schebler Carburetor Company Building was the company's original building at the Barth Avenue site. [3]
Fuel-saving devices are sold on the aftermarket with claims they may improve the fuel economy, the exhaust emissions, or optimize ignition, air flow, or fuel flow of automobiles in some way. An early example of such a device sold with difficult-to-justify claims is the 200 mpg ‑US (1.2 L/100 km) carburetor designed by Canadian inventor ...
In 1957 Chevrolet introduced their first fuel-injected engine, [12] the Rochester Ramjet high-performance option on Corvette and passenger cars at $484. [13] In 1956 Oldsmobile were also experimenting with Rochester fuel injection, at the GM desert proving grounds near Phoenix, but offered the Rochester triple-carburetor J2 option for 1957. [14]