Search results
Results from the WOW.Com Content Network
Bi-amping - An active crossover with two amplifiers. Bi-amping and tri-amping is the practice of using two or three audio amplifiers respectively to amplify different audio frequency ranges, with the amplified signals being routed to different speaker drivers, such as woofers, subwoofers and tweeters.
Bottom: bi-wiring. Loudspeaker bi-wired using banana plugs. Bi-wiring is a means of connecting a loudspeaker to an audio amplifier, primarily used in hi-fi systems. Normally, there is one pair of connectors on a loudspeaker and a single cable (two conductors) runs from the amplifier output to the terminals at the loudspeaker housing.
The four-pole connector is the most common at least from the availability of ready-made leads, as it allows for things like bi-amping (two of the four connections for the higher-frequency signal, with the other two for the lower-frequency signal) without two separate cables.
Bi-amping and tri-amping of a sound reinforcement system with the aid of a DLMS results in more efficient use of amplifier power by sending each amplifier only the frequencies appropriate for its respective loudspeaker and eliminating losses associated with passive crossover circuits.
The article describes active loudspeaker systems. In audiophile circles though, bi- or tri-amping refers to the act of hooking up multiple amps to the individual binding posts of a passive speaker where each amp and speaker terminal receives the full signal and the passive crossover still does what it always does.
In building wiring, multiway switching is the interconnection of two or more electrical switches to control an electrical load from more than one location.A common application is in lighting, where it allows the control of lamps from multiple locations, for example in a hallway, stairwell, or large room.
Two-wire circuits in new installations are limited to intercom and military field telephone applications, though these too are being supplanted by modern digital communication modes. To communicate in both directions in the same wire pair, conversion between four-wire and two-wire was necessary, both at the telephone and at the central office .
Entwistle also experimented throughout his career with 'Bi-amping', where the high and low ends of the bass are sent through separate signal paths, allowing for more control over the output. At one point his rig became so loaded down with speaker cabinets and processing gear that it was dubbed "Little Manhattan", in reference to the towering ...