Search results
Results from the WOW.Com Content Network
This is referred to as port security. Port security may be configured statically with a list, dynamically based on the first given number of addresses detected, or a combination of these two methods. When port security is configured, the default settings are to allow only one MAC address per port, and to shut down the port if the allowed number ...
Packet Tracer is a cross-platform visual simulation tool designed by Cisco Systems that allows users to create network topologies and imitate modern computer networks. The software allows users to simulate the configuration of Cisco routers and switches using a simulated command line interface.
Examples of connectionless systems are Ethernet, IP, and the User Datagram Protocol (UDP). Connection-oriented systems include X.25, Frame Relay, Multiprotocol Label Switching (MPLS), and TCP. In connectionless mode each packet is labeled with a destination address, source address, and port numbers.
Screenshot of Wireshark network protocol analyzer A packet analyzer (also packet sniffer or network analyzer) is a computer program or computer hardware such as a packet capture appliance that can analyze and log traffic that passes over a computer network or part of a network. Packet capture is the process of intercepting and logging traffic. As data streams flow across the network, the ...
In computer networking, a media access control attack or MAC flooding is a technique employed to compromise the security of network switches.The attack works by forcing legitimate MAC table contents out of the switch and forcing a unicast flooding behavior potentially sending sensitive information to portions of the network where it is not normally intended to go.
This port communicates with P-Ports and ports on the same community VLAN. Example scenario: a switch with VLAN 100, converted into a Private VLAN with one P-Port, two I-Ports in Isolated VLAN 101 (Secondary) and two community VLANs 102 and 103 (Secondary), with 2 ports in each. The switch has one uplink port (trunk), connected to another switch.
Controllers should listen on TCP port 6653 for switches that want to set up a connection. Earlier versions of the OpenFlow protocol unofficially used port 6633. [2] [3] Some network control plane implementations use the protocol to manage the network forwarding elements. [4] OpenFlow is mainly used between the switch and controller on a secure ...
These tables allow the switch to securely deliver the packet to its intended physical address only. Using the switch to connect only the systems that are communicating provides much greater security than a network hub, which broadcasts all traffic over all ports, [ 3 ] allowing an eavesdropper to intercept and monitor all network traffic.