Search results
Results from the WOW.Com Content Network
Screws into a light bulb socket to add two jacks, while still taking the bulb. Made in the US by Eagle Electric. By the early 1980s Eagle Electric was selling thousands of wiring device SKUs to hardware stores across the country. In 1991 Eagle Electric introduced a line of surge protector wiring devices under the brand eSmart, with the strong ...
GY6.35 & GZ6.35 – same as G6.35 and only denote what lamp mount clip is needed to hold the actual light bulb in place; G8 – 8 mm (0.31496 in) pin spacing GU8 – same as G8 and only denotes what lamp mount clip is needed to hold the actual light bulb in place; GY8.6 – 8.6 mm (0.33858 in) pin spacing; G9 – 9 mm (0.35433 in) pin spacing
An outlet is defined by the NEC as "a point in the wiring system at which current is taken to utilization equipment". [1] This definition includes receptacles, lighting, motors, etc. Ordinary switches control but do not consume electricity, and therefore are not defined as outlets in this sense.
These versions of the 5-15R or 5-20R receptacle are residual-current devices, and have "Test" and "Reset" buttons (and sometimes an indicator light which may be normally on or normally off per the vendor's design). In the US and Canada, GFCI protection is required for receptacles in many potentially wet locations, including outside outlets ...
The M12 connector, specified in IEC 61076-2-101, is a circular electrical plug/receptacle pair with 12mm OD mating threads, used in NMEA 2000, DeviceNet, IO-Link, some kinds of Industrial Ethernet, etc. [16] [17] A disadvantage of the circular design is its inefficient use of panel space when used in arrays, when compared to rectangular connectors.
A wide variety of special light fixtures are created for use in the automotive lighting industry, aerospace, marine and medicine sectors. [2] [3] Portable light fixtures are often called lamps, as in table lamp or desk lamp. In technical terminology, the lamp is the light source, which, in casual terminology, is called the light bulb.
When commercial electric power was first introduced in the 1880s, it was used primarily for lighting. Other portable appliances (such as vacuum cleaners, electric fans, smoothing irons, and curling-tong heaters) were connected to light-bulb sockets. As early as 1885 a two-pin plug and wall socket format was available on the British market.
In contrast to a simple light switch, which is a single pole, single throw (SPST) switch, multiway switching uses switches with one or more additional contacts and two or more wires are run between the switches. When the load is controlled from only two points, single pole, double throw (SPDT) switches are used.