Search results
Results from the WOW.Com Content Network
A chirp is a signal in which the frequency increases (up-chirp) or decreases (down-chirp) with time. In some sources, the term chirp is used interchangeably with sweep signal . [ 1 ] It is commonly applied to sonar , radar , and laser systems, and to other applications, such as in spread-spectrum communications (see chirp spread spectrum ).
In digital communications, chirp spread spectrum (CSS) is a spread spectrum technique that uses wideband linear frequency modulated chirp pulses to encode information. [1] A chirp is a sinusoidal signal whose frequency increases or decreases over time (often with a polynomial expression for the relationship between time and frequency).
The stationary phase method does not predict or deal with Fresnell ripples, so it is unable to offer any means by which these ripples can be minimized. As an example, the figure below shows a chirp spectrum with T. Δ F =250 obtained for a non-linear chirp aiming to match the Hamming window, using the methods described above. The figure shows ...
Harbor Freight Tools, commonly referred to as Harbor Freight, is an American privately held tool and equipment retailer, headquartered in Calabasas, California. It operates a chain of retail stores, as well as an e-commerce business. The company employs over 28,000 people in the United States, [5] and has over 1,500 locations in 48 states. [6] [7]
A current sensor is a device that detects electric current in a wire and generates a signal proportional to that current. The generated signal could be analog voltage or current or a digital output.
A chirp transmitter is a shortwave radio transmitter that sweeps the HF radio spectrum on a regular schedule. If one is monitoring a specific frequency, then a chirp is heard (in CW or SSB mode) when the signal passes through.
A transducer is a device that converts energy from one form to another. Usually a transducer converts a signal in one form of energy to a signal in another. [1] Transducers are often employed at the boundaries of automation, measurement, and control systems, where electrical signals are converted to and from other physical quantities (energy, force, torque, light, motion, position, etc.).
Angles are measured by the transceiver, which contains an array of transducers. The transceiver head normally contains three or more transducers separated by a baseline of 10 cm or less, hence the "short baseline" name. A method called “phase-differencing” within this transducer array is used to calculate the direction to the subsea ...