Search results
Results from the WOW.Com Content Network
Peeling paint: Water seeping through walls may lead to bubbling or peeling paint along basement walls. [4] Efflorescence: White, powdery residue found on basement walls near the floor. Mold: Fungi that usually grow in damp, dark areas and can cause respiratory problems after prolonged exposure.
Whitewash, calcimine, kalsomine, calsomine, asbestis or lime paint is a type of paint made from slaked lime (calcium hydroxide, Ca(OH) 2) or chalk (calcium carbonate, CaCO 3), sometimes known as "whiting". Various other additives are sometimes used.
As the footage shows, renovations included installing proper plumbing and heat in a couple of the rooms upstairs, painting over old wallpaper, and essentially bringing the house up to code just ...
Masonry walls are built with a damp-proof course to prevent rising damp, and the concrete in foundations needs to be damp-proofed or waterproofed with a liquid coating, basement waterproofing membrane (even under the concrete slab floor where polyethylene sheeting is commonly used), or an additive to the concrete.
Cement render or cement plaster is the application of a mortar mix of sand and cement, (optionally lime) and water to brick, concrete, stone, or mud brick. It is often textured, colored, or painted after application. It is generally used on exterior walls but can be used to feature an interior wall. [1]
Stamped concrete in various patterns, highlighted with acid stain. Decorative concrete is the use of concrete as not simply a utilitarian medium for construction but as an aesthetic enhancement to a structure, while still serving its function as an integral part of the building itself such as floors, walls, driveways, and patios.
Rising damp from the ground may be prevented by most simple means. Six inches of good Portland cement concrete should cover the whole site of the dwelling, and concrete never less than nine inches thick should underlie all walls. A damp course should disconnect the whole of the foundations from the superstructure.
The mold is then filled with epoxy and is heated or air-cured. The resulting part is very corrosion-resistant, stiff, and strong for its weight. Parts used in less critical areas are manufactured by draping cloth over a mold, with epoxy either pre-impregnated into the fibers (also known as pre-preg) or "painted" over it.