Search results
Results from the WOW.Com Content Network
A group of tell-tales showing lights for "brake fluid", "stop lamp" and "check engine" Graphical tell-talesA tell-tale, sometimes called an idiot light [1] or warning light, is an indicator of malfunction or operation of a system, indicated by a binary (on/off) illuminated light, symbol or text legend.
A check engine light or malfunction indicator lamp (MIL), is a tell-tale that a computerized engine-management system uses to indicate a malfunction or problem with the vehicle ranging from minor (such as a loose gas cap) to serious (worn spark plugs, engine problems or a faulty oil valve, etc.).
An indicator lamp (or indicator light) is an illuminated device that is intended to visually convey a single status to the user of a piece of equipment. Indicator lamp may refer to: Check engine light, a tell-tale warning light in automobiles; Tell-tale (automotive), a more generic class of indicators
The electromagnetic parking sensor (EPS) was re-invented and patented in 1992 by Mauro Del Signore. [2] Electromagnetic sensors rely on the vehicle moving slowly and smoothly towards the object to be avoided. Once an obstacle is detected, the sensor continues to signal the presence of the obstacle even if the vehicle momentarily stops.
Ideal test indicator pushed. Prior to modern geared dial mechanisms, test indicators using a single lever or systems of levers were common. The range and precision of these devices were generally inferior to modern dial type units, with a range of 10/1000 inch to 30/1000 inch, and precision of 1/1000 inch being typical.
A bad crank position sensor can worsen the way the engine idles, or the acceleration behaviour. If the engine is revved up with a bad or faulty sensor, it may cause misfiring, motor vibration or backfires. Acceleration might be hesitant, and abnormal shaking during engine idle might occur. In the worst case, the car may not start.
The TPS sensor along with the vehicle speed sensor are the two main inputs for most TCUs. Older transmissions use this to determine engine load, with the introduction of drive-by-wire technology, this is often a shared input between the ECU and TCU. The input is used to determine the optimum time and characteristics for a gear change according ...
An indicator chart records the pressure in the cylinder versus the volume swept by the piston, throughout the two or four strokes of the piston which constitute the engine, or compressor, cycle. The indicator diagram is used to calculate the work done and the power produced in an engine cylinder [2] or used in a compressor cylinder.