Search results
Results from the WOW.Com Content Network
Pin 1 is typically indicated on the body of the connector by a red or raised "V" mark. The corresponding wire in a ribbon cable is usually indicated by red coloration, a raised molded ridge, or markings printed onto the cable insulation. On the connector pin 2 is opposite pin 1, pin 3 is next to pin 1 along the length of the connector, and so on.
ITT has over 10,000 employees in more than 35 countries and serves customers in more than 100 countries. The company's long-standing brands include Goulds Pumps, Cannon connectors, KONI shock absorbers and Enidine energy absorption components. [4] The company was founded in 1920 as International Telephone & Telegraph.
In 2001, ITT Cannon purchased BIW, a manufacturer of electrical power connectors, cables and harnessing. BIW designed and manufactured the first power feedthru connectors for electric submersible pumps used in artificial lifts for oil wells, and the company developed the first field attachable connectors for electric submersible pump power cables.
It is very common in blogs and websites to incorrectly name a specific connector only by the name of the manufacturer. To minimize confusion, it is best to describe a connector using: the manufacturer's name, exact connector series, and optionally the pitch, such as "JST-XH" or "JST-XH-2.50mm" or "2.50mm JST XH-series" or other variations.
The first rubber-insulated cables for US building wiring were introduced in 1922 with US patent 1458803, Burley, Harry & Rooney, Henry, "Insulated electric wire", issued 1923-06-12, assigned to Boston Insulated Wire and Cable . These were two or more solid copper electrical wires with rubber insulation, plus woven cotton cloth over each ...
NEMA 1-15P (two-pole, no ground) and NEMA 5-15P (two-pole with ground pin) plugs are used on common domestic electrical equipment, and NEMA 5-15R is the standard 15-ampere electric receptacle (outlet) found in the United States, and under relevant national standards, in Canada (CSA C22.2 No. 42 [1]), Mexico (NMX-J-163-ANCE) and Japan (JIS C 8303).
The corresponding notch in the female connector body is 1.8 ± 0.1 mm (0.071 ± 0.004 in) wide and ends at a radius of 6.2 ± 0.1 mm (0.244 ± 0.004 in) from the connector centre. With the angles measured clockwise looking at the female connector (counter-clockwise looking at the male), the various key positions indicate:
Schematic symbols for male and female connector pins. In electrical and mechanical trades and manufacturing, each half of a pair of mating connectors or fasteners is conventionally designated as male or female, [1] a distinction referred to as its gender. [2] The female connector is generally a receptacle that receives and holds the male connector.