Search results
Results from the WOW.Com Content Network
Brake horsepower (bhp) is the power measured using a brake type (load) dynamometer at a specified location, such as the crankshaft, output shaft of the transmission, rear axle or rear wheels. [ 30 ] In Europe, the DIN 70020 standard tests the engine fitted with all ancillaries and the exhaust system as used in the car.
Engine power is the power that an engine can put out. It can be expressed in power units, most commonly kilowatt, pferdestärke (metric horsepower), or horsepower.In terms of internal combustion engines, the engine power usually describes the rated power, which is a power output that the engine can maintain over a long period of time according to a certain testing method, for example ISO 1585.
Brake horsepower per cubic centimeter or (bhp/cc) is a figure of merit that is used to indicate the 'state of tune' of an internal combustion engine. It is defined as the ratio of the engine's net power output to its displacement, the internal size. Power is measured at its rated speed and full throttle.
Total energy delivered from a single charge cycle is affected by both the battery temperature and the power it delivers. If the temperature lowers or the power demand increases, the total energy delivered at the point of "discharge" is also reduced. Battery discharge profiles are often described in terms of a factor of battery capacity. For ...
It is the rate of fuel consumption divided by the power produced. In traditional units, it measures fuel consumption in pounds per hour divided by the brake horsepower, lb/(hp⋅h); in SI units, this corresponds to the inverse of the units of specific energy, kg/J = s 2 /m 2. It may also be thought of as power-specific fuel consumption, for ...
In the power systems analysis field of electrical engineering, a per-unit system is the expression of system quantities as fractions of a defined base unit quantity. . Calculations are simplified because quantities expressed as per-unit do not change when they are referred from one side of a transformer to t
A field level (or root-power level) is a logarithmic quantity used to measure quantities of which the square is typically proportional to power (for instance, the square of voltage is proportional to power by the inverse of the conductor's resistance), etc., with commonly used units neper (Np) or decibel (dB).
High-precision laboratory measurements of electrical quantities are used in experiments to determine fundamental physical properties such as the charge of the electron or the speed of light, and in the definition of the units for electrical measurements, with precision in some cases on the order of a few parts per million. Less precise ...