Search results
Results from the WOW.Com Content Network
Rolls Royce Goblin II numbered cutaway; the impeller of the centrifugal compressor is number 12. The very first jet engines used centrifugal compressors and they are still used on small turbojets and turbo shaft engines. The key component that makes a compressor centrifugal is the centrifugal impeller which contains a rotating set of blades.
Rolls-Royce based the 10-stage HP compressor on an 8-stage run in the RB401 in the mid 1970's followed by a 9-stage run in the RJ.500. The V.2500 would use 10 stages, with the first 4 with variable stators, giving a pressure ratio of 20:1. [4] A single-stage booster was also part of the original configuration.
The Clyde used a two-shaft design, with an axial compressor based on that of the Metrovick F.2 [4] [5] for the low-pressure section, and a single-sided centrifugal compressor scaled up from the Merlin 46 supercharger [6] as the high-pressure stage, both mounted on the HP shaft and driven by a single stage HP turbine. A single stage power ...
The RB.106 was a two-shaft design with two axial flow compressors each driven by its own single stage turbine and reheat.It was of similar size to the Rolls-Royce Avon, allowing it to be used as a drop-in replacement, but it would have produced about twice the thrust (with reheat) at 21,750 lbf (96.7 kN).
The engine was designed for the Hughes AH-64 Apache and Sikorsky UH-60 Blackhawk, competing with the General Electric T700 and the Pratt & Whitney Canada PW100.The partners shared the £100 million development costs equally, Rolls-Royce made the turbines, the combustor, and the inlet particle separator while Turbomeca produced the axial-centrifugal compressor and intake.
A single-stage fan, driven by a three-stage LP turbine, supercharged the nine-stage HP compressor, which was driven by a two-stage air-cooled HP turbine. The combustor was annular and the exhaust separate jets. The HP compressor was based on a scale-up of the Rolls-Royce RB401 HP compressor, with a ninth stage added at the rear. Fan diameter ...
The Rolls-Royce RR500 is a family of small gas turbine engines developed by Rolls-Royce Corporation. The RR500TP turboprop variant was intended for use in small aircraft. The RR500TS was the turboshaft variant designed for light helicopters. Development of the RR500 was abandoned in 2012.
MTU Turbomeca Rolls-Royce GmbH (MTR) is a multinational engine manufacturer established to develop, manufacture, and service the MTR390 turboshaft engine. It is a joint venture by three European aero-engine manufacturers, Germany 's MTU Aero Engines , France 's Turbomeca and Britain 's Rolls-Royce .