enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Constant-voltage speaker system - Wikipedia

   en.wikipedia.org/wiki/Constant-voltage_speaker...

   Constant-voltage speaker systems are also commonly referred to as 25-, 70-, 70.7-, 100 or 210-volt speaker systems; distributed speaker systems; or high-impedance speaker systems. In Canada and the US, they are most commonly referred to as 70-volt speakers. In Europe, the 100 V system is the most widespread, with amplifier and speaker products ...

3. Gain (electronics) - Wikipedia

   en.wikipedia.org/wiki/Gain_(electronics)

   The term gain has a different meaning in antenna design; antenna gain is the ratio of radiation intensity from a directional antenna to / (mean radiation intensity from a lossless antenna). Graph of the input v i ( t ) {\displaystyle v_{i}(t)} (blue) and output voltage v o ( t ) {\displaystyle v_{o}(t)} (red) of an ideal linear amplifier with a ...

4. Full-range speaker - Wikipedia

   en.wikipedia.org/wiki/Full-range_speaker

   Several manufacturers build small (typically 115 mm (4.5")) diameter full-range drivers into miniature enclosures, and many of these include 25 or 70-volt line transformers, for use on commercial sound systems employing long speaker cables.

5. Harman Kardon - Wikipedia

   en.wikipedia.org/wiki/Harman_Kardon

   In 1959, Harman Kardon marketed the Citation II, an early ultra wideband stereophonic tube amplifier. It featured 60 watts/channel output with a frequency response of 18–60,000 Hz at 20 watt output. [20] The company promoted their philosophy of designing high fidelity sound using amplifiers that provided widest possible audio bandwidth.

6. RF power amplifier - Wikipedia

   en.wikipedia.org/wiki/RF_power_amplifier

   A radio-frequency power amplifier (RF power amplifier) is a type of electronic amplifier that converts a low-power radio-frequency (RF) signal into a higher-power signal. [1] Typically, RF power amplifiers are used in the final stage of a radio transmitter , their output driving the antenna .

7. Impedance matching - Wikipedia

   en.wikipedia.org/wiki/Impedance_matching

   Typical push–pull audio tube power amplifier, matched to loudspeaker with an impedance-matching transformer. Audio amplifiers typically do not match impedances, but provide an output impedance that is lower than the load impedance (such as < 0.1 ohm in typical semiconductor amplifiers), for improved speaker damping.