enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Head gasket - Wikipedia

   en.wikipedia.org/wiki/Head_gasket

   In an internal combustion engine, a head gasket provides the seal between the engine block and cylinder head(s). Its purpose is to seal the combustion gases within the cylinders and to avoid coolant or engine oil leaking into the cylinders. [1] Leaks in the head gasket can cause poor engine running and/or overheating.

3. Chevrolet big-block engine - Wikipedia

   en.wikipedia.org/wiki/Chevrolet_big-block_engine

   The 1970 Chevrolet Corvette LS-5 version of this engine was factory-rated at 390 bhp (395 PS; 291 kW) and 500 lb⋅ft (678 N⋅m), and the LS-6 engine equipped with a single 4-barrel 800 cu ft/min (23 m 3 /min) Holley carburetor was upgraded to 450 bhp (456 PS; 336 kW) at 5600 rpm and 500 lb⋅ft (678 N⋅m) at 3600 rpm of torque.

4. Chevrolet small-block engine (first- and second-generation)

   en.wikipedia.org/wiki/Chevrolet_small-block...

   The interchangeable parts include the rotating assembly (crank shaft, pistons, connecting rods, and flywheel/flex-plate) one piece rear main seal housing, oil pan and valve cover gaskets and valvetrain assembly (not including timing set, which includes a gear to drive the water pump). The LT1 uses a new engine block, cylinder head, timing cover ...

5. GM 6L transmission - Wikipedia

   en.wikipedia.org/wiki/GM_6L_transmission

   The 6L 50 (and similar 6L 45) is a 6-speed longitudinally-mounted automatic transmission produced by General Motors.It is very similar in design to the larger GM 6L 80 and 6L 90, and is produced at GM Powertrain plants in Toledo, Ohio; Silao, Guanajuato, Mexico; and by the independent Punch Powerglide company in Strasbourg, France.

6. General Motors LS-based small-block engine - Wikipedia

   en.wikipedia.org/wiki/General_Motors_LS-based...

   The 4.8L and the 5.3L are smaller truck versions of the LS1 and were designed to replace the 305 and the 350 in trucks. The 4.8L and 5.3L engines share the same Gen III LS-series engine block and heads (upper end) and therefore, most parts interchange freely between these engines and other variants in the LS family.

7. List of GM bellhousing patterns - Wikipedia

   en.wikipedia.org/wiki/List_of_GM_bellhousing...

   The 2.2l S10/Sonoma had the starter located in the same position as front wheel drive cars. A rear wheel drive bellhousing is displayed at right, and the integrated front wheel drive bellhousing is displayed at the lower right (in this case, as a part of the GM 6T70 Transmission). GM 60-Degree 2.8/3.1/3.4/3.5/3.9 L V6 (also used by AMC) Buick ...