Search results
Results from the WOW.Com Content Network
Distributed temperature sensing systems (DTS) are optoelectronic devices which measure temperatures by means of optical fibres functioning as linear sensors. Temperatures are recorded along the optical sensor cable, thus not at points, but as a continuous profile. A high accuracy of temperature determination is achieved over great distances.
ESP Easy firmware is primarily used on modules/hardware using one of the many Espressif manufactured processor as a wireless Wi-Fi sensor device with added sensors for temperature, humidity, barometric pressure, light intensity, etc. The ESP Easy firmware also offers some low-level actuator functions to control relays. [10] [11] [12] [13]
The integrated circuit sensor may come in a variety of interfaces — analogue or digital; for digital, these could be Serial Peripheral Interface, SMBus/I 2 C or 1-Wire.. In OpenBSD, many of the I 2 C temperature sensors from the below list have been supported and are accessible through the generalised hardware sensors framework [3] since OpenBSD 3.9 (2006), [4] [5]: §6.1 which has also ...
The silicon bandgap temperature sensor is an extremely common form of temperature sensor (thermometer) used in electronic equipment. Its main advantage is that it can be included in a silicon integrated circuit at very low cost.
Distributed fiber-optic sensing technology can be used for leak detection through DAS and DTS. [26] AP Sensing has a regional office in Bahrain, and operates throughout the Middle East. [27] Their Distributed Fibre Optic Sensing is designed to monitor pipeline leaks, and is used by the Kuwait Oil Company and the Abu Dhabi National Oil Company.
ESP32 is a series of low-cost, low-power system-on-chip microcontrollers with integrated Wi-Fi and dual-mode Bluetooth.The ESP32 series employs either a Tensilica Xtensa LX6 microprocessor in both dual-core and single-core variations, an Xtensa LX7 dual-core microprocessor, or a single-core RISC-V microprocessor and includes built-in antenna switches, RF balun, power amplifier, low-noise ...
By measuring the ratio in intensity between the Stokes and anti-Stokes components, an absolute value of temperature can be measured by a distributed temperature sensing (DTS) system. The larger wavelength shifts compared to Brillouin scatter mean that it is easier to separate the scattered Raman light from the un-shifted Rayleigh scattered ...
Another possibility to minimize the temperature dependence of a heat flux sensor, is to use a resistance network with an incorporated thermistor. The temperature dependence of the thermistor will balance the temperature dependence of the thermopile. Another factor that determines heat flux sensor behavior, is the construction of the sensor.