Search results
Results from the WOW.Com Content Network
During a rollover, or when a wave washes over the craft, its engine can hydrolock, though severe damage is rare due to the special air intakes and low rotating inertia of small marine engines. Inboard marine engines have a different vulnerability as these often have their cooling water mixed with the exhaust gases in the header to quiet the engine.
With both inboards and stern drives there is a fire and explosion hazard from gasoline fuel vapors within the engine compartment. Typically these boats must run a blower for several minutes prior to starting the engine, and when idling or moving below cruise speed. The blower exchanges the air within the engine compartment with fresh outside air.
Perkins Diesel Conversions & Factory fitted units, by Allan T. Condie, 2nd edition 2000, ISBN 0-907742-79-3 The 4 107T was used in UK Military electricity generating sets, the engines when in need an overhaul were rebuilt by a Kent based engineering works in Ramsgate, adjacent to the inner Harbour known as Walkers Marine (Marine Engineers) Ltd. Houchins of Ashford an MOD contractor would send ...
A 16-horsepower (12 kW) inboard marine diesel engine, installed in a sailboat Engine room layout of a rescue boat An 11,100-horsepower (8,300 kW) 5-cylinder, 2-stroke, low-speed marine diesel engine, powering a ship. The first marine craft to utilize inboard motors were steam engines going back to 1805 and the Clermont and the Charlotte Dundas ...
Headquarters A Mercury 50 HP outboard motor circa 1980 Six cylinder two-stroke engine in 1984. Mercury Marine is a marine engine division of Brunswick Corporation headquartered in Fond du Lac, Wisconsin. The main product line is outboard motors. It also produces the MerCruiser line of sterndrives and inboard engines, as well as a lineup of ...
The Universal Atomic 4 is a four-cylinder, gasoline engine produced by the Universal Motor Company between 1949 [1] and 1984 for use as auxiliary power on sailboats. [2] Both 18 horsepower (13 kW) and 30 horsepower (22 kW) versions of the engine were produced. [ 3 ]
Starting fluid is not recommended for regular use with some two-stroke engines because it does not possess lubricating qualities by itself. Lubrication for two-stroke engines is achieved using oil that is either mixed into the fuel by the user or injected automatically into the fuel supply; engines requiring premixed fuel that are run solely on starting fluid do not receive an adequate supply ...
The original company that made Johnson inboard motors and outboard motors was the Johnson Brothers Motor Company of Terre Haute, Indiana, United States. They started building inboard 2-cycle marine engines in 1903 in a barn behind the house, along with matching boats. By 1908, they were making V4, V6, V8, and V12 aircraft and marine engines.