Search results
Results from the WOW.Com Content Network
The engine is typically activated by a key and a starting motor switch. Upon turning the key and pressing the starting motor switch, the oil pressure alarm will ring for about a second until the engine starts to run. The exit of cooling water from the exhaust into the sea (typically at the aft of the boat) should be checked at that time. After ...
During a rollover, or when a wave washes over the craft, its engine can hydrolock, though severe damage is rare due to the special air intakes and low rotating inertia of small marine engines. Inboard marine engines have a different vulnerability as these often have their cooling water mixed with the exhaust gases in the header to quiet the engine.
Perkins Diesel Conversions & Factory fitted units, by Allan T. Condie, 2nd edition 2000, ISBN 0-907742-79-3 The 4 107T was used in UK Military electricity generating sets, the engines when in need an overhaul were rebuilt by a Kent based engineering works in Ramsgate, adjacent to the inner Harbour known as Walkers Marine (Marine Engineers) Ltd. Houchins of Ashford an MOD contractor would send ...
A bad crank position sensor can worsen the way the engine idles, or the acceleration behaviour. If the engine is revved up with a bad or faulty sensor, it may cause misfiring, motor vibration or backfires. Acceleration might be hesitant, and abnormal shaking during engine idle might occur. In the worst case, the car may not start.
The Universal Atomic 4 is a four-cylinder, gasoline engine produced by the Universal Motor Company between 1949 [1] and 1984 for use as auxiliary power on sailboats. [2] Both 18 horsepower (13 kW) and 30 horsepower (22 kW) versions of the engine were produced. [ 3 ]
A 260-horsepower (190 kW) diesel inboard motor An inboard motor is a marine propulsion system for boats.As opposed to an outboard motor, where an engine is mounted outside the hull of the craft, an inboard motor is an engine enclosed within the hull of the boat, usually connected to a propulsion screw by a driveshaft.
An automobile starter motor (larger cylinder). The smaller object on top is a starter solenoid which controls power to the starter motor and engages the Bendix drive.. A starter (also self-starter, cranking motor, or starter motor) is a device used to rotate (crank) an internal-combustion engine so as to initiate the engine's operation under its own power.
The original company that made Johnson inboard motors and outboard motors was the Johnson Brothers Motor Company of Terre Haute, Indiana, United States. They started building inboard 2-cycle marine engines in 1903 in a barn behind the house, along with matching boats. By 1908, they were making V4, V6, V8, and V12 aircraft and marine engines.