Search results
Results from the WOW.Com Content Network
Araldite adhesive is used to join together the two sections of carbon composite which make up the monocoque of the Lamborghini Aventador. The use of Araldite adhesive in architecture to bond thin joints of pre-cast concrete units was pioneered by Ove Arup in Coventry cathedral and the Sydney Opera House. [4]
Copper has a very linear resistance–temperature relationship; however, copper oxidizes at moderate temperatures and cannot be used over 150 °C (302 °F). [citation needed] The significant characteristic of metals used as resistive elements is the linear approximation of the resistance versus temperature relationship between 0 and 100 °C.
Over small changes in temperature, if the right semiconductor is used, the resistance of the material is linearly proportional to the temperature. There are many different semiconducting thermistors with a range from about 0.01 kelvin to 2,000 kelvins (−273.14 °C to 1,700 °C).
The result was Aerolite, a urea-formaldehyde adhesive which unlike conventional glues of the time, resisted water and micro-organisms. Further research showed that gap-bridging hardeners incorporating formic acid enabled Aerolite to be used as an assembly adhesive. Aerolite was the first adhesive of its type to be invented and manufactured in ...
Uses of pneumatic pressure switches include: Switch a household well water pump automatically when water is drawn from the pressure tank. Switching off an electrically driven gas compressor when a set pressure is achieved in the reservoir; Switching off a gas compressor, whenever there is no feed in the suction stage. in-cell charge control in ...
Bonding at specific temperature, ambient pressure for specific amount of time; Post-bake/hard-cure to form solid BCB monomer layer; The wafers can be cleaned using H 2 O 2 + H 2 SO 4 or oxygen plasma. The cleaned wafers are rinsed with DI water and dried at elevated temperature, e.g. 100 to 200 °C for 120 min. [17]
Depending on the chemical basis, some adhesive types have limited thermal and chemical resistance and the mechanical properties of the bond are temperature dependent. Therefore, choose a type of adhesive that has been developed to have good thermal and chemical resistance, such as reactive hot melt adhesives.
Thermal adhesive is a type of thermally conductive glue used for electronic components and heat sinks. It can be available as a paste (similar to thermal paste) or as a double-sided tape. [1] It is commonly used to bond integrated circuits to heatsinks where there are no other mounting mechanisms available.