Search results
Results from the WOW.Com Content Network
Also known as impact ripples, these occur in the lower part of the lower flow regime sands with grain sizes between 0.3-2.5 mm and normal ripples form wavelengths of 7-14 cm. Normal ripples have straight or slightly sinuous crests approximately transverse to the direction of the wind.
This diamond is a mineral from within an igneous or metamorphic rock that formed at high temperature and pressure. The rock cycle is a basic concept in geology that describes transitions through geologic time among the three main rock types: sedimentary, metamorphic, and igneous.
Although symmetrical ripples are also called bi-directional ripples there is a difference between them. Bi-directional ripples are rarely symmetrical due to the difference in force of the two directions, where as the wave formed or oscillation ripples form from the circular water movement pattern of water molecules. These ripples form parallel ...
Wave ripple or symmetric ripple, from Permian rocks in Nomgon, Mongolia with "decapitation" of ripple crests due to change in current. Ripple marks usually form in conditions with flowing water, in the lower part of the Lower Flow Regime. There are two types of ripple marks: Symmetrical ripple marks
A schematic diagram of where the different types of sediment load are carried in the flow. Dissolved load is not sediment: it is composed of disassociated ions moving along with the flow. It may, however, constitute a significant proportion (often several percent, but occasionally greater than half) of the total amount of material being ...
This figure describes the geological aspects and processes of the carbonate silicate cycle, within the long-term carbon cycle. The carbonate–silicate geochemical cycle, also known as the inorganic carbon cycle, describes the long-term transformation of silicate rocks to carbonate rocks by weathering and sedimentation, and the transformation of carbonate rocks back into silicate rocks by ...
Cyclic sediments (also called rhythmic sediments [1]) are sequences of sedimentary rocks that are characterised by repetitive patterns of different rock types or facies within the sequence. Processes that generate sedimentary cyclicity can be either autocyclic or allocyclic, and can result in piles of sedimentary cycles hundreds or even ...
In geology, a bed is a layer of sediment, sedimentary rock, or volcanic rock "bounded above and below by more or less well-defined bedding surfaces". [1] A bedding surface is three-dimensional surface , planar or curved, that visibly separates each successive bed (of the same or different lithology ) from the preceding or following bed.