enow.com Web Search

Search results

  1. Results from the WOW.Com Content Network
  2. Bolted joint - Wikipedia

    en.wikipedia.org/wiki/Bolted_joint

    The applied torque causes the bolt to "climb" the thread causing a tensioning of the bolt and an equivalent compression in the components being fastened by the bolt. The preload developed in a bolt is due to the applied torque and is a function of the bolt diameter, the geometry of the threads, and the coefficients of friction that exist in the ...

  3. Preload control - Wikipedia

    en.wikipedia.org/wiki/Preload_control

    torque-angle tightening (also known as torque-angle tension control) is a method of securing the bolted joint when the initial tension is critical for reliability and safety. The technique relies on simultaneous monitoring of both the torque applied during the tightening as well as the angle of rotation, usually using a torque/angle wrench.

  4. Torque-to-yield fastener - Wikipedia

    en.wikipedia.org/wiki/Torque-to-yield_fastener

    The torque applied to the fastener must be determined such that it does not contribute to a service condition where the fastener enters a low-cycle fatigue regime. In general, the use of torque-to-yield fasteners is deprecated except in cases where the materials and structures comprising the entire assembly are certified to be within tolerances.

  5. Multi-jackbolt tensioner - Wikipedia

    en.wikipedia.org/wiki/Multi-jackbolt_tensioner

    Multi-jackbolt tensioners (MJTs), registered under the trademark Superbolt or Supernut, are designed to decrease the torque required to tighten large bolted joints. One of the major problems associated with traditional bolt tightening methods is as the diameter of the bolt increases, the amount of torque required to tighten it increases in the third power of the diameter. [1]

  6. Pound-foot (torque) - Wikipedia

    en.wikipedia.org/wiki/Pound-foot_(torque)

    Similarly, an inch-pound (or pound-inch) is the torque of one pound of force applied to one inch of distance from the pivot, and is equal to 1 ⁄ 12 lbf⋅ft (0.1129848 N⋅m). It is commonly used on torque wrenches and torque screwdrivers for setting specific fastener tension.

  7. Direct tension indicator - Wikipedia

    en.wikipedia.org/wiki/Direct_tension_indicator

    DTIs within the RCSC specification section 8.2.4 are described thus: "ASTM F959 direct tension indicators are recognized in this Specification as a bolt-tension-indicating device. Direct tension indicators are hardened washer shaped devices incorporating small arch-like protrusions on the bearing surface that are designed to deform in a ...

  8. Torque - Wikipedia

    en.wikipedia.org/wiki/Torque

    In physics and mechanics, torque is the rotational analogue of linear force. [1] It is also referred to as the moment of force (also abbreviated to moment). The symbol for torque is typically , the lowercase Greek letter tau. When being referred to as moment of force, it is commonly denoted by M.

  9. List of screw and bolt types - Wikipedia

    en.wikipedia.org/wiki/List_of_screw_and_bolt_types

    A tension control bolt (TC bolt) is a heavy duty bolt used in steel frame construction. The head is usually domed and is not designed to be driven. The end of the shank has a spline on it which is engaged by a special power wrench which prevents the bolt from turning while the nut is tightened. When the appropriate torque is reached the spline ...