Ads
related to: 3 8 stainless hydraulic tubingnortherntool.com has been visited by 100K+ users in the past month
Search results
Results from the WOW.Com Content Network
JIC hydraulic fitting from 1967 Ford backhoe. It was badly stuck, but shows what a JIC fitting looks like. The left is the male part, the right is female. A JIC bulkhead adapter, which converts National Pipe Thread (NPT) on the left to JIC on the right. The angled seating surface is clearly visible on the far right.
Nitronic 60 and a similar alloy Gall-Tough were specifically developed to have superior resistance to galling, a form of wear caused by adhesion between sliding surfaces, and metal-to-metal wear. [8] Nitronic 60 alloy represents a nitrogen-reinforced austenitic stainless steel recognized for its exceptional ability to withstand corrosion.
These pipe clamps are similar to hose clamps, but are heavier-duty and ideally are made completely of stainless steel (including the screw) to provide maximum service life. [ 22 ] : 149 [ 19 ] : 71 Optionally, the entire rubber sleeve may be jacketed with thin sheet metal, to provide extra stiffness, durability, and resistance to accidental ...
In tube hydroforming pressure is applied to the inside of a tube that is held by dies with the desired cross sections and forms. When the dies are closed, the tube ends are sealed by axial punches and the tube is filled with hydraulic fluid. The internal pressure can go up to a few thousand bars and it causes the tube to calibrate against the dies.
Both pipe and tube imply a level of rigidity and permanence, whereas a hose is usually portable and flexible. A tube and pipe may be specified by standard pipe size designations, e.g., nominal pipe size, or by nominal outside or inside diameter and/or wall thickness. The actual dimensions of pipe are usually not the nominal dimensions: A 1-inch ...
The tool used to flare tubing consists of a die that grips the tube, and either a mandrel or rolling cone is forced into the end of the tube to form the flare by cold working. The most common flare fitting standards in use today are the 45° SAE flare [2] [3],the 37° JIC flare, and the 37° AN flare.
Ads
related to: 3 8 stainless hydraulic tubingnortherntool.com has been visited by 100K+ users in the past month