Search results
Results from the WOW.Com Content Network
Vertical pipes, usually made of precast concrete, called manholes, connect the mains to the surface. Depending upon site application and use, these vertical pipes can be cylindrical, eccentric, or concentric. The manholes are used for access to the sewer pipes for inspection and maintenance, and as a means to vent sewer gases.
A sewer pipe is normally at neutral air pressure compared to the surrounding atmosphere.When a column of waste water flows through a pipe, it compresses air ahead of it in the system, creating a positive pressure that must be released so it does not push back on the waste stream and downstream traps, slow drainage, and induce potential clogs.
A fitting or adapter is used in pipe systems to connect sections of pipe (designated by nominal size, with greater tolerances of variance) or tube (designated by actual size, with lower tolerance for variance), adapt to different sizes or shapes, and for other purposes such as regulating (or measuring) fluid flow.
The drain is characterized by its long length and narrow width, the cross-section of the drain is a function of the maximum flow volume anticipated from the surrounding surface. Channels can range from 1 inch (2.5 cm) to 2 feet (61 cm) in width, while depths can reach up to 4 feet (120 cm).
Roman roofs used lead in conduits and drain pipes [14] and some were also covered with lead. Lead was also used for piping and for making baths. [15] Plumbing reached its early apex in ancient Rome, which saw the introduction of expansive systems of aqueducts, tile wastewater removal, and widespread use of lead pipes.
High-density polyethylene pipe installation in a storm drain project, Mexico. Drainage is the natural or artificial removal of a surface's water and sub-surface water from an area with excess water. The internal drainage of most agricultural soils can prevent severe waterlogging (anaerobic conditions that harm root growth), but many soils need ...
Pipelayers hanging a pipe on the wall of the Church Avenue station of the New York City Subway. A pipelayer (or pipe-layer or drain layer) is a skilled tradesman who lays pipe, such as for storm sewers, sanitary sewers, drains, and water mains. [1] Pipelayers may grade (i.e., level) trenches and culverts, position pipe, or seal joints. [1]
Storm drain; Sanitary sewers not relying solely on gravity include: Vacuum sewer; Effluent sewer; Where a sewerage system has not been installed, sewage may be collected from homes by pipes into septic tanks or cesspits, where it may be treated or collected in vehicles and taken for treatment or disposal (a process known as fecal sludge ...