Search results
Results from the WOW.Com Content Network
The CPU power states C0–C3 are defined as follows: C0 is the operating state. C1 (often known as Halt) is a state where the processor is not executing instructions, but can return to an executing state essentially instantaneously. All ACPI-conformant processors must support this power state.
The power management for microprocessors can be done over the whole processor, or in specific components, such as cache memory and main memory. With dynamic voltage scaling and dynamic frequency scaling, the CPU core voltage, clock rate, or both, can be altered to decrease power consumption at the price of potentially lower performance. This is ...
ACPI 1.0 (1996) defines a way for a CPU to go to idle "C states", but defines no frequency-scaling system. ACPI 2.0 (2000) introduces a system of P states (power-performance states) that a processor can use to communicate its possible frequency–power settings to the OS. The operating system then sets the speed as needed by switching between ...
PC power management refers to software-based mechanisms for controlling the power use of personal computer hardware. This is typically achieved through software that puts the hardware into the lowest power demand state available, making it an aspect of green computing .
Thermal Design Power (TDP), also known as thermal design point, is the maximum amount of heat that a computer component (like a CPU, GPU or system on a chip) can generate and that its cooling system is designed to dissipate during normal operation at a non-turbo clock rate (base frequency).
Active-state power management (ASPM) is a power management mechanism for PCI Express devices to garner power savings while otherwise in a fully active state. Predominantly, this is achieved through active-state link power management; i.e., the PCI Express serial link is powered down when there is no traffic across it.
APM defines five power states for the computer system: Full On: The computer is powered on, and no devices are in a power saving mode. APM Enabled: The computer is powered on, and APM is controlling device power management as needed. APM Standby: Most devices are in their low-power state, the CPU is slowed or stopped, and the system state is saved.
CPU modes (also called processor modes, CPU states, CPU privilege levels and other names) are operating modes for the central processing unit of most computer architectures that place restrictions on the type and scope of operations that can be performed by instructions being executed by the CPU.