enow.com Web Search

  1. Ads

    related to: bad control arm bushing symptoms
    • KYB

      State of the Art Gas

      Shocks and Struts.

    • H&R

      Consistent Suspension

      Performance on the Street or Track.

Search results

  1. Results from the WOW.Com Content Network
  2. Control arm - Wikipedia

    en.wikipedia.org/wiki/Control_arm

    In automotive suspension, a control arm, also known as an A-arm, is a hinged suspension link between the chassis and the suspension upright or hub that carries the wheel. In simple terms, it governs a wheel's vertical travel, allowing it to move up or down when driving over bumps, into potholes, or otherwise reacting to the irregularities of a ...

  3. Radius rod - Wikipedia

    en.wikipedia.org/wiki/Radius_rod

    A radius rod (also called a radius arm, torque arm, torque spring, and torsion bar) is a suspension link intended to control wheel motion in the longitudinal (fore-aft) direction. The link is connected (with a rubber or solid bushing) on one end to the wheel carrier or axle, on the other to the chassis or unibody of the vehicle. Radius rods are ...

  4. Multi-link suspension - Wikipedia

    en.wikipedia.org/wiki/Multi-link_suspension

    Typically each arm has a spherical joint (ball joint) or rubber bushing at each end. Consequently, they react to loads along their own length, in tension and compression, but not in bending. Some multi-links do use a trailing arm, control arm or wishbone, which has two bushings at one end.

  5. Anti-roll bar - Wikipedia

    en.wikipedia.org/wiki/Anti-roll_bar

    As the anti-roll bar is required to control wheel position, the bars of a MacPherson strut suspension may be connected through ball joints. However many later "MacPherson strut" suspensions have reverted to using wishbones rather than the simplified track control arm of the original design.

  6. Automotive suspension design process - Wikipedia

    en.wikipedia.org/wiki/Automotive_suspension...

    The compliance of the bushings, the body, and other parts modify the behaviour of the suspension. In general it is difficult to improve the kinematics of a suspension using the bushings, but one example where it does work is the toe control bush used in Twist-beam rear suspensions .

  7. Steering knuckle - Wikipedia

    en.wikipedia.org/wiki/Steering_knuckle

    In the attached photograph of a double-wishbone suspension, the knuckle is shown attached to the upper control arm at the top and the lower control arm at the bottom. The wheel assembly is shown attached to the knuckle at its center point.

  1. Ads

    related to: bad control arm bushing symptoms