Search results
Results from the WOW.Com Content Network
The 866 is a mercury vapor half-wave rectifier intended for high-voltage applications. The voltage drop is approximately 15 volts up to 150 Hz. To avoid unwanted shorts the tube must be operated in a vertical position and the filament preheated for at least 30 seconds before applying the plate voltage.
In half-wave rectification of a single-phase supply, either the positive or negative half of the AC wave is passed, while the other half is blocked. Because only one half of the input waveform reaches the output, mean voltage is lower. Half-wave rectification requires a single diode in a single-phase supply, or three in a three-phase supply.
The characteristics and components of ripple depend on its source: there is single-phase half- and full-wave rectification, and three-phase half- and full-wave rectification. Rectification can be controlled (uses Silicon Controlled Rectifiers (SCRs)) or uncontrolled (uses diodes). There is in addition, active rectification which uses transistors.
UA025A – 10 kV, 250 mA Argon-filled, half-wave rectifier with an E27 Edison screw lamp base and an anode screw top cap; UA5A – 11 kV, 5 A Half-wave mercury-vapor rectifier with a 2-pin base and an anode screw top cap; ZD1000F – Radiation-cooled power triode up to 60 MHz, 1 kW; ZD1XB – Air-cooled AF power triode up to 1.2 kW
Pulsed DC is commonly produced from AC (alternating current) by a half-wave rectifier or a full-wave rectifier. Full wave rectified ac is more commonly known as Rectified AC. PDC has some characteristics of both alternating current (AC) and direct current (DC) waveforms. The voltage of a DC wave is roughly constant, whereas the voltage of an AC ...
Between the circuit's input and output is a diode that performs half-wave rectification, allowing substantial current flow only when the input voltage is around a diode drop higher than the output terminal. The output is connected to a capacitor of value and resistor of value in parallel to ground. The capacitor is charged as the input voltage ...
Voltage multipliers can be used to generate a few volts for electronic appliances, to millions of volts for purposes such as high-energy physics experiments and lightning safety testing. The most common type of voltage multiplier is the half-wave series multiplier, also called the Villard cascade (but actually invented by Heinrich Greinacher).
In areas using 110–120 volt AC, a simple half-wave rectifier limited the maximum plate voltage that could be developed; this was adequate for relatively low-power audio equipment, but television receivers or higher-powered amplifiers required either a more complex voltage doubler rectifier or warranted the use of a power transformer with a ...