Search results
Results from the WOW.Com Content Network
The related ping utility is implemented using the ICMP echo request and echo reply messages. ICMP uses the basic support of IP as if it were a higher-level protocol, however, ICMP is actually an integral part of IP. Although ICMP messages are contained within standard IP packets, ICMP messages are usually processed as a special case ...
Pinging involves sending an ICMP echo request to the target host and waiting for an ICMP echo reply. The program reports errors, packet loss , and a statistical summary of the results, typically including the minimum, maximum, the mean round-trip times, and standard deviation of the mean.
The Echo Protocol is a service in the Internet Protocol Suite defined in 1983 in RFC 862 by Jon Postel. It was originally proposed as a way to test and measure an IP network. A host may connect to a server that supports the Echo Protocol using the Transmission Control Protocol (TCP) or the User Datagram Protocol (UDP) on the well-known port ...
BWPing is a tool to measure bandwidth and response times between two hosts using Internet Control Message Protocol echo request/echo reply mechanism. [1] It does not require any special software on the remote host. The only requirement is the ability to respond on ICMP echo request messages. [2] BWPing supports both IPv4 and IPv6 networks. [3]
ICMP Internet Control Message Protocol: RFC 792: 0x02 2 IGMP Internet Group Management Protocol: RFC 1112: 0x03 3 GGP Gateway-to-Gateway Protocol: RFC 823: 0x04 4 IP-in-IP IP in IP (encapsulation) RFC 2003: 0x05 5 ST Internet Stream Protocol: RFC 1190, RFC 1819: 0x06 6 TCP Transmission Control Protocol: RFC 793: 0x07 7 CBT Core-based trees: RFC ...
A functionality which lets a computer A find out whether a computer B is reachable and responding is built into the Internet Control Message Protocol (ICMP). Through an "Echo Request" Computer A asks B to send back an "Echo Reply". [2] These two messages are also sometimes called "ping" and "pong" for historical purposes. [citation needed]
ICMP tunneling works by injecting arbitrary data into an echo packet sent to a remote computer. The remote computer replies in the same manner, injecting an answer into another ICMP packet and sending it back. The client performs all communication using ICMP echo request packets, while the proxy uses echo reply packets.
On Windows, tracert sends ICMP Echo Request packets, rather than the UDP packets traceroute sends by default. [11] The time-to-live (TTL) value, also known as hop limit, is used in determining the intermediate routers being traversed towards the destination. Traceroute sends packets with TTL values that gradually increase from packet to packet ...