Ads
related to: lathe chuck adapterebay.com has been visited by 1M+ users in the past month
toolots.com has been visited by 10K+ users in the past month
Search results
Results from the WOW.Com Content Network
Jawed chucks may require a wrench-like device called a chuck key to be tightened or loosened, but other jawed chucks may be tightened or loosened by hand force alone, offering convenience at the expense of gripping force. Chucks on some lathes have jaws that move independently, allowing them to hold irregularly shaped objects.
Drill chucks mounted by Jacobs tapers onto arbors with Morse tapers for the spindle. Spindle nose on a lathe headstock. The small female taper is a Morse taper to take a lathe center or a tool such as a twist drill. The large male taper takes a lathe chuck, which is retained by the large nut.
The faceplate was the ancestor of lathe chucks, an arrangement of three or more adjustable 'dogs' bolted to the faceplate providing a primitive chuck arrangement. The smaller plate in the upper photo is specifically a 'dog face' with slots intended to hold a bent tail dog while the work itself was supported on centers.
Several machine collets (top and centre) and a dismantled pin chuck (below). Generally, a collet chuck, [3] considered as a unit, consists of a tapered receiving sleeve (sometimes integral with the machine spindle), the collet proper (usually made of spring steel) which is inserted into the receiving sleeve, and (often) a cap that screws over the collet, clamping it via another taper.
The standard Presta valve has an external thread. An adapter can be fitted onto this external thread to permit the Presta valve to be connected to a pump with a Schrader chuck. The same adapter, because of a coincidence of thread sizes, may be able to convert a Schrader pump into one that can connect to flexible adapters of either kind. [4]
Indexable bits with the same purpose, to be held either in indexable handles or in power tool chucks, are called nutsetters. A spinner handle is a shaft and handle with a drive fitting—most commonly 1 ⁄ 4 in (6.35 mm) square axle at the end for attaching interchangeable sockets. This allows one to use a single handle with a number of sizes ...
Ads
related to: lathe chuck adapterebay.com has been visited by 1M+ users in the past month
toolots.com has been visited by 10K+ users in the past month