Search results
Results from the WOW.Com Content Network
Reasons for measuring throughput in networks. People are often concerned about measuring the maximum data throughput in bits per second of a communications link or network access. A typical method of performing a measurement is to transfer a 'large' file from one system to another system and measure the time required to complete the transfer or ...
Throughput Accounting uses three measures of income and expense: The chart illustrates a typical throughput structure of income (sales) and expenses (TVC and OE). T=Sales less TVC and NP=T less OE. Throughput (T) is the rate at which the system produces "goal units".
The packet transmission time in seconds can be obtained from the packet size in bit and the bit rate in bit/s as: Packet transmission time = Packet size / Bit rate. Example: Assuming 100 Mbit/s Ethernet, and the maximum packet size of 1526 bytes, results in Maximum packet transmission time = 1526×8 bit / (100 × 10 6 bit/s) ≈ 122 μs
The system throughput or aggregate throughput is the sum of the data rates that are delivered over all channels in a network. [1] Throughput represents digital bandwidth consumption. The throughput of a communication system may be affected by various factors, including the limitations of the underlying physical medium, available processing ...
Throughput is the actual rate that information is transferred Latency the delay between the sender and the receiver decoding it, this is mainly a function of the signals travel time, and processing time at any nodes the information traverses
TamoGraph is used for measuring and visualizing such WLAN characteristics [5] as signal strength, signal-to-noise ratio, signal-to-interference ratio, TCP and UDP throughput rates, access point vendor, encryption type, [citation needed] etc. [6] Visualizations are overlaid on floor plans [7] or, in case of outdoor surveys, on site maps that can be imported from one of the online map services.
The figures below are simplex data rates, which may conflict with the duplex rates vendors sometimes use in promotional materials. Where two values are listed, the first value is the downstream rate and the second value is the upstream rate. The use of decimal prefixes is standard in data communications.
rates the fairness of a set of values where there are users, is the throughput for the th connection, and ^ is the sample coefficient of variation. The result ranges from 1 n {\displaystyle {\tfrac {1}{n}}} (worst case) to 1 (best case), and it is maximum when all users receive the same allocation.