Ads
related to: db25 ribbon connector kit cross reference chart framtemu.com has been visited by 1M+ users in the past month
- Top Sale Items
Daily must-haves
Special for you
- Store Locator
Team up, price down
Highly rated, low price
- Our Picks
Highly rated, low price
Team up, price down
- All Clearance
Daily must-haves
Special for you
- Top Sale Items
Search results
Results from the WOW.Com Content Network
An IEEE 1284 36-pin male micro ribbon printer cable connection. The computer side normally uses a DB-25 port instead of this connector. IEEE 1284, also known as the Centronics port, is a standard that defines bi-directional parallel communications between computers and other devices.
Because personal computers first used DB-25 connectors for their serial and parallel ports, when the PC serial port began to use 9-pin connectors, they were often labeled as DB-9 instead of DE-9 connectors, due to an ignorance of the fact that B represented a shell size. It is now common to see DE-9 connectors sold as DB-9 connectors.
1A1A44J5 - Unit 1, Assembly 1, Sub-Assembly 44, Jack 5 (J5 is a connector on a box referenced as A44) 1A1A45J333 - Unit 1, Assembly 1, Sub-Assembly 45, Jack 333 (J333 is a connector on a box referenced as A45) A cable connecting these two might be: 1A1W35 - In the assembly A1 is a cable called W35. Connectors on this cable would be designated:
Left: 20-way grey ribbon cable with wire for pin 1 marked red, insulation partly stripped. Right: 16-way rainbow ribbon with IDC connector. IDC D-sub connectors DE-9 (male) and DA-15 (female) Twisted ribbon cable used for Parallel SCSI connections. A ribbon cable is a cable with many conducting wires running parallel to each other on the same ...
When IBM implemented the parallel interface on the IBM PC, they used the DB-25F connector at the PC-end of the interface, creating the now familiar parallel cable with a DB25M at one end and a 36-pin micro ribbon connector at the other. In theory, the Centronics port could transfer data as rapidly as 75,000 characters per second.
A DB-25 connector as described in the RS-232 standard Data circuit-terminating equipment (DCE) and data terminal equipment (DTE) network. In telecommunications, RS-232 or Recommended Standard 232 [1] is a standard originally introduced in 1960 [2] for serial communication transmission of data.
Generally, serial port connectors are gendered, only allowing connectors to mate with a connector of the opposite gender. With D-subminiature connectors, the male connectors have protruding pins, and female connectors have corresponding round sockets. [2] Either type of connector can be mounted on equipment or a panel; or terminate a cable.
3.5-inch and 5.25-inch drives connect to the floppy controller using a 34-conductor flat ribbon cable for signal and control. Most controllers support two floppy drives, although the Shugart standard supports up to four drives attached to a single controller. A cable could have 5.25-inch style connectors, 3.5-inch style connectors, or a ...
Ads
related to: db25 ribbon connector kit cross reference chart framtemu.com has been visited by 1M+ users in the past month