Search results
Results from the WOW.Com Content Network
A sieve analysis (or gradation test) is a practice or procedure used in geology, civil engineering, [1] and chemical engineering [2] to assess the particle size distribution (also called gradation) of a granular material by allowing the material to pass through a series of sieves of progressively smaller mesh size and weighing the amount of material that is stopped by each sieve as a fraction ...
The Fineness Modulus (FM) is an empirical figure obtained by adding the total percentage of the sample of an aggregate retained on each of a specified series of sieves, dividing the sum by 100. Sieves sizes are: 150-μm (No. 100), 300-μm (No. 50), 600-μm (No. 30), 1.18-mm (No. 16), 2.36-mm (No. 8), 4.75-mm (No. 4), 9.5-mm (3/8-in.), 19.0-mm ...
Sieve estimators have been used extensively for estimating density functions in high-dimensional spaces such as in Positron emission tomography (PET). The first exploitation of Sieves in PET for solving the maximum-likelihood image reconstruction problem was by Donald Snyder and Michael Miller, [1] where they stabilized the time-of-flight PET problem originally solved by Shepp and Vardi. [2]
Unlike sieve analyses which can be time-consuming and inaccurate, taking a photo of a sample of the materials to be measured and using software to analyze the photo can result in rapid, accurate measurements. Another advantage is that the material can be analyzed without being handled.
50 g of air dried coal featuring a grain size in the range between 0.6 and 1.18 mm are filled into the sample mill and a weight is put on the mill's grinding stone. After 60 rounds the grinded coal is put on a sampling sieve. Factor D equals the fraction of the coal passing through the sieve of 74 μm corresponding to 200 mesh.
A higher sand equivalent value indicates that there is less clay‐like material in a sample. During the test, material from the test specimen that can pass through a No. 4 sieve is mixed with solutions of calcium chloride, formaldehyde and glycerin in a cylinder. The content is then left for sedimentation. After about 20 minutes, the level of ...
For example, a sample from a truckload of peanuts may be placed atop a mesh with 5 mm openings. When the mesh is shaken, small broken pieces and dust pass through the mesh while whole peanuts are retained on the mesh. A commercial peanut buyer might use a test like this to determine if a batch of peanuts has too many broken pieces.
Statistical tests are used to test the fit between a hypothesis and the data. [1] [2] Choosing the right statistical test is not a trivial task. [1] The choice of the test depends on many properties of the research question. The vast majority of studies can be addressed by 30 of the 100 or so statistical tests in use. [3] [4] [5]