enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Bolted joint - Wikipedia

   en.wikipedia.org/wiki/Bolted_joint

   Torque charts are available to specify the required torque for a given fastener based on its property class (fineness of manufacture and fit) and grade (tensile strength). Spring Analogy for a Bolted Joint. When a fastener is tightened, a tension preload is develops in the bolt, while an equal compressive preload forms in the clamped parts.

3. Wrench size - Wikipedia

   en.wikipedia.org/wiki/Wrench_size

   The table below shows dimensions of metric spanners for selected sizes of metric threads. [2] Note that with ISO 272 1982 the width across flats for M10, M12, M14 and M22 were changed from 17, 19, 22 and 32 mm respectively to the current standard.

4. ISO 898 - Wikipedia

   en.wikipedia.org/wiki/ISO_898

   ISO 898 is an international standard that defines mechanical and physical properties for metric fasteners. This standard is the origin for other standards that define properties for similar metric fasteners, such as SAE J1199 and ASTM F568M. [1] It is divided into five (nonconsecutive) parts: 1.

5. Torque wrench - Wikipedia

   en.wikipedia.org/wiki/Torque_wrench

   A click torque wrench. A torque wrench is a tool used to apply a specific torque to a fastener such as a nut, bolt, or lag screw.It is usually in the form of a socket wrench with an indicating scale, or an internal mechanism which will indicate (as by 'clicking', a specific movement of the tool handle in relation to the tool head) when a specified (adjustable) torque value has been reached ...

6. Preload control - Wikipedia

   en.wikipedia.org/wiki/Preload_control

   torque-angle tightening (also known as torque-angle tension control) is a method of securing the bolted joint when the initial tension is critical for reliability and safety. The technique relies on simultaneous monitoring of both the torque applied during the tightening as well as the angle of rotation, usually using a torque/angle wrench.

7. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   The hex drive is better than square drive for locations where surrounding obstacles limit wrenching access, because smaller wrench-swing arcs can still successfully rotate the fastener. Metric sizes of the hex are specified by ISO 4032 and ISO 4033, plus ISO 4035 for Jam Nuts, and ISO 4014 and ISO 4017 for hex cap screws, ISO 4018 for Hex head ...