Search results
Results from the WOW.Com Content Network
If the sender has not received acknowledgement for the first packet it sent, it will stop and wait and if this wait exceeds a certain limit, it may even retransmit. This is how TCP achieves reliable data transmission. Even if there is no packet loss in the network, windowing can limit throughput. Because TCP transmits data up to the window size ...
Large packets occupy a link for more time than a smaller packet, causing greater delays to subsequent packets, and increasing network delay and delay variation. For example, a 1500-byte packet, the largest allowed by Ethernet at the network layer, ties up a 14.4k modem for about one second.
A network packet is the fundamental building block for packet-switched networks. [15] When an item such as a file, e-mail message, voice or video stream is transmitted through the network, it is broken into chunks called packets that can be more efficiently moved through the network than one large block of data.
The relative scalability of network data throughput as a function of packet transfer rates is related in a complex manner to payload size per packet. [17] Theoretically, as line bit rate increases, the packet payload size should increase in direct proportion to maintain equivalent timing parameters.
TCP offload engine (TOE) is a technology used in some network interface cards (NIC) to offload processing of the entire TCP/IP stack to the network controller. It is primarily used with high-speed network interfaces, such as gigabit Ethernet and 10 Gigabit Ethernet, where processing overhead of the network stack becomes significant.
A typical method of performing a measurement is to transfer a 'large' file from one system to another system and measure the time required to complete the transfer or copy of the file. The throughput is then calculated by dividing the file size by the time to get the throughput in megabits, kilobits, or bits per second.
The approach taken is to increase the transmission rate (window size), probing for usable bandwidth, until loss occurs. The policy of additive increase may, for instance, increase the congestion window by a fixed amount every round-trip time. When congestion is detected, the transmitter decreases the transmission rate by a multiplicative factor ...
In addition, there is a basic layer-3 aggregation [20] that allows servers with multiple IP interfaces on the same network to perform load balancing, and for home users with more than one internet connection, to increase connection speed by sharing the load on all interfaces.