Ad
related to: increasing network packet size is one of the best tool storage- New PowerEdge Servers
Autonomous Collaboration
With New Intel Xeon Scalable
- Dell Technologies APEX
As-A-Service, At Your Fingertips
All Available With A Single Click
- New PowerEdge Servers
Search results
Results from the WOW.Com Content Network
If the sender has not received acknowledgement for the first packet it sent, it will stop and wait and if this wait exceeds a certain limit, it may even retransmit. This is how TCP achieves reliable data transmission. Even if there is no packet loss in the network, windowing can limit throughput. Because TCP transmits data up to the window size ...
Large packets occupy a link for more time than a smaller packet, causing greater delays to subsequent packets, and increasing network delay and delay variation. For example, a 1500-byte packet, the largest allowed by Ethernet at the network layer, ties up a 14.4k modem for about one second.
The maximum segment size (MSS) is a parameter of the Options field of the TCP header that specifies the largest amount of data, specified in bytes, that a computer or communications device can receive in a single TCP segment. It does not count the TCP header or the IP header (unlike, for example, the MTU for IP datagrams).
A network packet is the fundamental building block for packet-switched networks. [15] When an item such as a file, e-mail message, voice or video stream is transmitted through the network, it is broken into chunks called packets that can be more efficiently moved through the network than one large block of data.
The relative scalability of network data throughput as a function of packet transfer rates is related in a complex manner to payload size per packet. [17] Theoretically, as line bit rate increases, the packet payload size should increase in direct proportion to maintain equivalent timing parameters.
The packet transmission time in seconds can be obtained from the packet size in bit and the bit rate in bit/s as: Packet transmission time = Packet size / Bit rate. Example: Assuming 100 Mbit/s Ethernet, and the maximum packet size of 1526 bytes, results in Maximum packet transmission time = 1526×8 bit / (100 × 10 6 bit/s) ≈ 122 μs
RFC 2992 analyzed one particular multipath routing strategy involving the assignment of flows through hashing flow-related data in the packet header. This solution is designed to avoid these problems by sending all packets from any particular network flow through the same path while balancing multiple flows over multiple paths in general. [2]
TCP offload engine (TOE) is a technology used in some network interface cards (NIC) to offload processing of the entire TCP/IP stack to the network controller. It is primarily used with high-speed network interfaces, such as gigabit Ethernet and 10 Gigabit Ethernet, where processing overhead of the network stack becomes significant.
Ad
related to: increasing network packet size is one of the best tool storage