enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Bolted joint - Wikipedia

   en.wikipedia.org/wiki/Bolted_joint

   The applied torque causes the bolt to "climb" the thread causing a tensioning of the bolt and an equivalent compression in the components being fastened by the bolt. The preload developed in a bolt is due to the applied torque and is a function of the bolt diameter, the geometry of the threads, and the coefficients of friction that exist in the ...

3. List of Ford bellhousing patterns - Wikipedia

   en.wikipedia.org/wiki/List_of_Ford_bellhousing...

   Note: this is commonly called the Ford Small-block V8 pattern, though it is used in some "big block"-sized V8's as well as some V6's and I6's. 200 I6 1978-1983 only, partial (4 of 6 bolts) pattern. 250 I6 (except Australian 250/4.1) 255 V8; 289 V8 - (made after August 3, 1964) - had 6 bolts holding bellhousing to block; 302 Cleveland (Australia)

4. Key (engineering) - Wikipedia

   en.wikipedia.org/wiki/Key_(engineering)

   Tangent keys are used in high-torque heavy-duty applications. What would have been the side of each keyway forms heels against which the key sits, and transfers force compressively. This latter point means that for reversible motion of the shaft, another key along a tangent outwards in the opposing direction is needed.

5. List of GM bellhousing patterns - Wikipedia

   en.wikipedia.org/.../List_of_GM_bellhousing_patterns

   Also called the GM small corporate pattern and the S10 pattern. This pattern has a distinctive odd-sided hexagonal shape. Rear wheel drive applications have the starter mounted on the right side of the block (when viewed from the flywheel) and on the opposite side of the block compared to front wheel drive installations.

6. List of screw drives - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_drives

   Either method leaves only a smooth bolt head exposed. This type of bolt is commonly used with prison door locks, automobile ignition switches, and street signs, to prevent easy removal. An alternative design leaves a low-profile button head visible after installation. [74] In addition to breakaway bolts, breakaway nuts of similar design are ...

7. ISO metric screw thread - Wikipedia

   en.wikipedia.org/wiki/ISO_metric_screw_thread

   The thread depth is 0.54125 × pitch. The outermost 1 ⁄ 8 and the innermost 1 ⁄ 4 of the height H of the V-shape are cut off from the profile. The relationship between the height H and the pitch P is found using the following equation where θ is half the included angle of the thread, in this case 30°: [3]

8. Wrench size - Wikipedia

   en.wikipedia.org/wiki/Wrench_size

   For instance, a bolt for a 1-inch nominal diameter thread might have flats that are 1.5 inches apart. The wrench for this bolt should have flats that are between 1.508 and 1.520 inches apart to allow for a little extra space between the nut flats and the bolt flats.

9. Fastener - Wikipedia

   en.wikipedia.org/wiki/Fastener

   Structural bolt DIN 6914 with DIN 6916 washer and UNI 5587 nut. A threaded fastener has internal or external screw threads. [7] The most common types are the screw, nut and bolt, possibly involving washers. Other more specialized types of threaded fasteners include captive threaded fasteners, stud, threaded inserts, and threaded rods.