Search results
Results from the WOW.Com Content Network
In a computer, an interrupt request (or IRQ) is a hardware signal sent to the processor that temporarily stops a running program and allows a special program, an interrupt handler, to run instead. Hardware interrupts are used to handle events such as receiving data from a modem or network card , key presses, or mouse movements.
A hardware interrupt is a condition related to the state of the hardware that may be signaled by an external hardware device, e.g., an interrupt request (IRQ) line on a PC, or detected by devices embedded in processor logic (e.g., the CPU timer in IBM System/370), to communicate that the device needs attention from the operating system (OS) [7] or, if there is no OS, from the bare metal ...
The traditional form of interrupt handler is the hardware interrupt handler. Hardware interrupts arise from electrical conditions or low-level protocols implemented in digital logic, are usually dispatched via a hard-coded table of interrupt vectors, asynchronously to the normal execution stream (as interrupt masking levels permit), often using ...
The interrupt priority level (IPL) is a part of the current system interrupt state, which indicates the interrupt requests that will currently be accepted. The IPL may be indicated in hardware by the registers in a programmable interrupt controller , or in software by a bitmask or integer value and source code of threads.
That could carry a significant speed hit, since it requires switching between two memory address spaces every time there's a system call or a hardware interrupt request. Fix for Intel's massive ...
The IRR specifies which interrupts are pending acknowledgement, and is typically a symbolic register which can not be directly accessed. The ISR register specifies which interrupts have been acknowledged, but are still waiting for an end of interrupt (EOI). The IMR specifies which interrupts are to be ignored and not acknowledged.
The process issues a system call (sometimes called a software interrupt); for example, an I/O request occurs requesting to access a file on a hard disk. A hardware interrupt occurs; for example, a key was pressed on the keyboard, or a timer runs out (used in preemptive multitasking).
This means that if the CPU requests data from a disk, for example, it does not need to busy-wait until the read is over; it can issue the request (to the I/O device) and continue with some other task. When the read is over, the CPU can be interrupted (by a hardware in this case, which sends interrupt request to PIC) and