Search results
Results from the WOW.Com Content Network
This 350-cubic-inch engine was a different design than the Chevy's 350 CID engine (4.000 in × 3.48 in) the Buick design had a longer stroke and smaller bore (3.80 X 3.85 in) allowing for lower-end torque, deep-skirt block construction, higher nickel-content cast iron, 3.0 in (76 mm) crank main journals, and 6.5 in (165 mm) connecting rods, the ...
The 322 Fireball V8 in a 1956 Buick Century. Buick's first generation V8 was offered from 1953 through 1956; it replaced the Buick straight-eight.While officially called the "Fireball V8" [1] by Buick, it became known by enthusiasts as the "Nailhead" for the unusual vertical alignment of its small-sized valves (Originally it was known to hot-rodders as the "nail valve", because the engine's ...
1965 Buick Gran Sport. The 1965 Skylark Gran Sport was the intermediate Buick Skylark with the Gran Sport option added. Although a 300 cubic inches (4.9 litres) V8 was already offered in the Skylark, the Gran Sport had the largest engine permitted by GM - a 401 cubic inches (6.6 litres) Buick V8 (called a 400 by Buick because that was the maximum engine size allowed in intermediate body cars).
From 1964-1967, Buick and Oldsmobile versions of this transmission used a torque converter with a variable-pitch stator called Switch-Pitch (by Buick) or Variable Vane (by Oldsmobile). The stator blades moved from high to low position by an electrical solenoid and a stator valve, controlled by a switch on the throttle linkage. At light to ...
The Buick V6 is an OHV V6 engine developed by the Buick division of General Motors and first introduced in 1962. The engine was originally 198 cu in (3.2 L) and was marketed as the Fireball engine. GM continued to develop and refine the 231 cu in (3.8 L) V6, eventually and commonly referred to simply as the 3800, through numerous iterations.
Goodyear tires are built to last, but these babies have lasted longer than most. Nearly 60 years! Anson Renshaw, 54, of Mesa, Arizona, owns a 1966 Buick Wildcat with original Goodyear Power ...
The aluminum V8 was replaced by conventional cast-iron block V8s of 300 cubic inches for the Buick Special/Skylark and 330 inches for the Oldsmobile F-85/Cutlass, while Pontiac carried over its 326 cubic-inch V8 to the '64 Tempest/LeMans line while switching the base engine from the four-cylinder to a 215 cubic-inch inline six-cylinder.
The engine blocks used for 215-V8 engines installed in Tempest models were distinct from 215-V8 engine blocks used in other models because, in addition to Buick factory markings, they were also hand-stamped at the Pontiac plant with the Vehicle Identification Numbers of the individual vehicles that they were installed in. Thus, in 1961, all ...