Search results
Results from the WOW.Com Content Network
The decibel originates from methods used to quantify signal loss in telegraph and telephone circuits. Until the mid-1920s, the unit for loss was miles of standard cable (MSC). 1 MSC corresponded to the loss of power over one mile (approximately 1.6 km) of standard telephone cable at a frequency of 5000 radians per second (795.8 Hz), and matched closely the smallest attenuation detectable to a ...
dBm or dB mW (decibel-milliwatts) is a unit of power level expressed using a logarithmic decibel (dB) scale respective to one milliwatt (mW). It is commonly used by radio, microwave and fiber-optical communication technicians & engineers to measure the power of system transmissions on a log scale , which can express both very large and very ...
It is essential to know which category a measurement belongs to when using decibels (dB) for comparing the levels of such quantities. A change of one bel in the level corresponds to a 10× change in power, so when comparing power quantities x and y, the difference is defined to be 10×log 10 (y/x) decibel.
In telecommunications, [1] particularly in radio frequency engineering, signal strength refers to the transmitter power output as received by a reference antenna at a distance from the transmitting antenna. High-powered transmissions, such as those used in broadcasting, are expressed in dB-millivolts per metre (dBmV/m).
It is usually defined as the mean ratio of the signal amplitude or power at the output port to the amplitude or power at the input port. [1] It is often expressed using the logarithmic decibel (dB) units ("dB gain"). [4]
dBc (decibels relative to the carrier) is the power ratio of a signal to a carrier signal, expressed in decibels.For example, phase noise is expressed in dBc/Hz at a given frequency offset from the carrier. dBc can also be used as a measurement of Spurious-Free Dynamic Range between the desired signal and unwanted spurious outputs resulting from the use of signal converters such as a digital ...
The OSNR is the ratio between the signal power and the noise power in a given bandwidth. Most commonly a reference bandwidth of 0.1 nm is used. This bandwidth is independent of the modulation format, the frequency and the receiver. For instance an OSNR of 20 dB/0.1 nm could be given, even the signal of 40 GBit DPSK would not fit in this bandwidth.
Decibels relative to full scale (dBFS or dB FS) is a unit of measurement for amplitude levels in digital systems, such as pulse-code modulation (PCM), which have a defined maximum peak level. The unit is similar to the units dBov and decibels relative to overload (dBO). [1] The level of 0 dBFS is assigned to the maximum possible digital level. [2]