enow.com Web Search

  1. Ads

    related to: hdpe pipe fittings chart

Search results

  1. Results from the WOW.Com Content Network
  2. HDPE pipe - Wikipedia

    en.wikipedia.org/wiki/HDPE_pipe

    HDPE pipe is a type of flexible plastic pipe used to transfer fluids and gases. It is often employed for replacing aging concrete or steel main pipelines . Constructed from the thermoplastic HDPE (high-density polyethylene ), it has low permeability and robust molecular bonding, making it suitable for high-pressure pipelines .

  3. Plastic pipework - Wikipedia

    en.wikipedia.org/wiki/Plastic_pipework

    Plastic Pipe lengths manufactured in Australia by extruding HDPE material.. Plastic pipe is a tubular section, or hollow cylinder, made of plastic.It is usually, but not necessarily, of circular cross-section, used mainly to convey substances which can flow—liquids and gases (fluids), slurries, powders and masses of small solids.

  4. Piping and plumbing fitting - Wikipedia

    en.wikipedia.org/wiki/Piping_and_plumbing_fitting

    [19]: 71 The rubber sleeves are typically secured with stainless steel worm drive clamping bands, which compress the rubber to make a tight seal around the pipes and fittings. These pipe clamps are similar to hose clamps, but are heavier-duty and ideally are made completely of stainless steel (including the screw) to provide maximum service life.

  5. High-density polyethylene - Wikipedia

    en.wikipedia.org/wiki/High-density_polyethylene

    HDPE is known for its high strength-to-density ratio. [4] The density of HDPE ranges from 930 to 970 kg/m 3. [5] Although the density of HDPE is only marginally higher than that of low-density polyethylene, HDPE has little branching, giving it stronger intermolecular forces and tensile strength (38 MPa versus 21 MPa) than LDPE. [6]

  6. Use of HDPE in nuclear power plant piping systems - Wikipedia

    en.wikipedia.org/wiki/Use_of_HDPE_in_Nuclear...

    Pipe Surface Alignment: A change in the pipe outside diameter (O.D.) surface misalignment of more than 10 percent of the wall thickness of the thinner member to be fused. (3) PE Material: Each lot of polyethylene source material to be used in production (XXVI–2310(c)). (4) Wall Thickness: Each thickness to be fused in production (XXVI–2310(c)).

  7. Back-up ring - Wikipedia

    en.wikipedia.org/wiki/Back-up_ring

    Pipeline Flange Adapter and Back-up Ring connection HDPE to steel pipe. The back-up ring is matched to the steel pipe flange specification and is placed behind the HDPE flange adapter - an end piece on the HDPE pipe that looks much like a steel flange at the end of the HDPE pipe.

  1. Ads

    related to: hdpe pipe fittings chart