Ad
related to: hi-speed usb device download driver
Search results
Results from the WOW.Com Content Network
For example, a USB 2 PCIe host controller card that presents 4 USB "Standard A" connectors typically presents one 4-port EHCI and two 2-port OHCI controllers to system software. When a high-speed USB device is attached to any of the 4 connectors, the device is managed through one of the 4 root hub ports of the EHCI controller.
The OHCI driver provides low- and full-speed functions for USB ports of all other motherboard chipset vendors' integrated USB host controllers or discrete host controllers attached to the computer's expansion bus. The EHCI driver provided high-speed functions for USB ports on the motherboard or on the discrete USB controller.
The idle line state is when the device is connected to the host with a pull-up on either D+ (for full speed USB 1.x) or D− (for low speed USB 1.x), with transmitter output on both host and device is set to high impedance (hi-Z) (disconnected output). A USB device pulls one of the data lines high with a 1.5 kΩ resistor.
The USB-IF used WiGig Serial Extension v1.2 specification as its initial foundation for the MA-USB specification and is compliant with SuperSpeed USB (3.0 and 3.1) and Hi-Speed USB (USB 2.0). Devices that use MA-USB will be branded as "Powered by MA-USB", provided the product qualifies its certification program. [104]
USB 3.0 SuperSpeed and USB 2.0 High-Speed versions defined USB 3.0 SuperSpeed – host controller (xHCI) hardware support, no software overhead for out-of-order commands; USB 2.0 High-speed – enables command queuing in USB 2.0 drives; Streams were added to the USB 3.0 SuperSpeed protocol for supporting UAS out-of-order completions
The Linux kernel has supported USB mass-storage devices since version 2.3.47 [3] (2001, backported to kernel 2.2.18 [4]).This support includes quirks and silicon/firmware bug workarounds as well as additional functionality for devices and controllers (vendor-enabled functions such as ATA command pass-through for ATA-USB bridges, used for S.M.A.R.T. or temperature monitoring, controlling the ...
In USB 3.0, dual-bus architecture is used to allow both USB 2.0 (Full Speed, Low Speed, or High Speed) and USB 3.0 (SuperSpeed) operations to take place simultaneously, thus providing backward compatibility. The structural topology is the same, consisting of a tiered star topology with a root hub at level 0 and hubs at lower levels to provide ...
USB 2.0 provides for a maximum cable length of 5 metres (16 ft 5 in) for devices running at high speed (480 Mbit/s). The primary reason for this limit is the maximum allowed round-trip delay of about 1.5 μs. If USB host commands are unanswered by the USB device within the allowed time, the host considers the command lost.
Ad
related to: hi-speed usb device download driver