enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Axial fan design - Wikipedia

   en.wikipedia.org/wiki/Axial_fan_design

   The stall zone for the single axial fan and axial fans operated in parallel are shown in the figure. [4] The Figure shows the Stall Prone Areas differently for One fan and Two fans in parallel. [4] The following can be inferred from the graph : For the Fans operated in parallel, the performance is less when compared to the individual fans.

3. Industrial fan - Wikipedia

   en.wikipedia.org/wiki/Industrial_fan

   The axial fan is often contained within a short section of cylindrical ductwork, to which inlet and outlet ducting can be connected. Axial fan types have fan wheels with diameters that usually range from less than a foot (0.3 meters) to over 30 feet (9.1 m), although axial cooling tower fan wheels may exceed 82 feet (25 m) in diameter.

4. Fan (machine) - Wikipedia

   en.wikipedia.org/wiki/Fan_(machine)

   This type of fan is used in a wide variety of applications, ranging from small cooling fans for electronics to the giant fans used in cooling towers. Axial flow fans are applied in air conditioning and industrial process applications. Standard axial flow fans have diameters of 300–400 mm or 1,800–2,000 mm and work under pressures up to 800 ...

5. Computer fan - Wikipedia

   en.wikipedia.org/wiki/Computer_fan

   Where noise is an issue, larger, slower-turning fans are quieter than smaller, faster fans that can move the same airflow. Fan noise has been found to be roughly proportional to the fifth power of fan speed; halving the speed reduces the noise by about 15 dB. [22] Axial fans may rotate at speeds of up to around 38,000 rpm for smaller sizes. [23]

6. AOL Mail

   mail.aol.com

   Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!

7. Affinity laws - Wikipedia

   en.wikipedia.org/wiki/Affinity_laws

   The affinity laws are useful as they allow the prediction of the head discharge characteristic of a pump or fan from a known characteristic measured at a different speed or impeller diameter. The only requirement is that the two pumps or fans are dynamically similar, that is, the ratios of the fluid forced are the same.