Search results
Results from the WOW.Com Content Network
where is the void ratio, is the porosity, V V is the volume of void-space (gases and liquids), V S is the volume of solids, and V T is the total (or bulk) volume. This figure is relevant in composites, in mining (particular with regard to the properties of tailings), and in soil science.
The coefficient of permeability varies with the void ratio as e/sup>/(1+e). For a given soil, the greater the void ratio, the higher the value of the coefficient of permeability. Here 'e' is the void ratio. Based on other concepts it has been established that the permeability of a soil varies as e 2 or e 3 /(1+e). Whatever may be the exact ...
where: is the "maximum void ratio" corresponding to a very loose state, is the "minimum void ratio" corresponding to a very dense state and is the in situ void ratio. Methods used to calculate relative density are defined in ASTM D4254-00(2006).
e 0 is the initial void ratio. H is the height of the compressible soil. σ zf is the final vertical stress. σ z0 is the initial vertical stress. When stress is removed from a consolidated soil, the soil will rebound, regaining some of the volume it had lost in the consolidation process.
Porosity or void fraction is a measure of the void (i.e. "empty") spaces in a material, and is a fraction of the volume of voids over the total volume, between 0 and 1, or as a percentage between 0% and 100%. Strictly speaking, some tests measure the "accessible void", the total amount of void space accessible from the surface (cf. closed-cell ...
e is the void ratio; Saturated unit weight The unit weight of a soil when all void spaces of the soil are completely filled with water, with no air. The formula for saturated unit weight is: = (+) + where γ s is the saturated unit weight of the material; γ w is the unit weight of water
This phenomenon of soil behaviour can be included in the Hardening Soil model by means of a dilatancy cut-off. In order to specify this behaviour, the initial void ratio, e i n i t {\displaystyle e_{init}} , and the maximum void ratio, e m a x {\displaystyle e_{max}} , of the material must be entered as general parameters.
Additional criticisms are that the theory is "only descriptive," i.e., only describes known behavior and lacking the ability to either explain or predict standard soil behaviors such as, why the void ratio in a one dimensional compression test varies linearly with the logarithm of the vertical effective stress.