enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Silicone rubber - Wikipedia

   en.wikipedia.org/wiki/Silicone_rubber

   A variety of fillers can be used in silicone rubber, although most are non-reinforcing and lower the tensile strength. Silicone rubber is available in a range of hardness levels, expressed as Shore A or IRHD between 10 and 100, the higher number being the harder compound. It is also available in virtually any colour, and can be colour matched.

3. Elastomeric connector - Wikipedia

   en.wikipedia.org/wiki/Elastomeric_connector

   A "matrix" version consists of short, fine, metallic wires, 300 to 2,000 per square centimeter, aligned parallel but not touching each other, embedded in a rubber sheet. [3] The wires can either protrude slightly from the top and bottom of the rubber sheet, or be curved and flush with the top and bottom planes; the latter is used for repeated ...

4. RTV silicone - Wikipedia

   en.wikipedia.org/wiki/RTV_silicone

   Silicones also exhibit good chemical resistance and high-temperature resistance (205 °C, 400 °F and higher). For this reason, silicone molds are suitable for casting low-melt metals and alloys (e.g. zinc, tin, pewter, and Wood's metal). RTV silicone rubbers are, however, generally expensive – especially platinum-cure.

5. Tear resistance - Wikipedia

   en.wikipedia.org/wiki/Tear_resistance

   D2212-00(2015) Standard Test Method for Slit Tear Resistance of Leather; D2582-16 Standard Test Method for Puncture-Propagation Tear Resistance of Plastic Film and Thin Sheeting; D4932/D4932M-89(2014)e1 Standard Test Method for Fastener Rupture and Tear Resistance of Roofing and Waterproofing Sheets, Roll Roofing, and Shingles

6. Release agent - Wikipedia

   en.wikipedia.org/wiki/Release_agent

   The matrix is created by the other ingredients in the semi-permanent mold release. Applications of semi-permanent mold release vary from every cycle to once daily applications depending on the compound being molded and the design and quality of the mold. Silicone-based rubber products, however, require a non-silicone based releasing agent.

7. Silicone - Wikipedia

   en.wikipedia.org/wiki/Silicone

   Silicone caulk can be used as a basic sealant against water and air penetration. In organosilicon and polymer chemistry, a silicone or polysiloxane is a polymer composed of repeating units of siloxane (−O−R 2 Si−O−SiR 2 −, where R = organic group). They are typically colorless oils or rubber-like substances. Silicones are used in ...