Search results
Results from the WOW.Com Content Network
The amplifier had a very simple circuit and used only a single channel with a two-stage preamp, with just a volume and (treble-cut) tone control. The Harvard was a fixed bias amplifier, using a basic cathodyne phase inverter, but did include a selenium rectifier in the bias circuit. The 5F10 was discontinued in 1961.
Bias voltage-15V: Anode resistance: 12 kilohms: Typical class-AB amplifier operation (Values are for two tubes) Power output: 100W: Anode voltage: 600V: Anode current: 100mA: Screen voltage: 350V: Bias voltage-45 (class AB2) References; Super Radiotron Tube Manual, Amalgamated Wireless Valve Co. Australia, June 1962 Radio Tube Data, Eighth Ed ...
A SET tube audio amplifier. A single-ended triode (SET) is a vacuum tube electronic amplifier that uses a single triode to produce an output, in contrast to a push-pull amplifier which uses a pair of devices with antiphase inputs to generate an output with the wanted signals added and the distortion components subtracted.
A graphical representation of the current and voltage properties of a transistor; the bias is selected so that the operating point permits maximum signal amplitude without distortion. In electronics, biasing is the setting of DC (direct current) operating conditions (current and voltage) of an electronic component that processes time-varying ...
The purpose of T2 and T3 is to allow back-biasing diode D2 when the amplifier output is at a positive peak (above 39.3 V) and back biasing D4 when the output is at negative peak less than -39.3 V. During the musical peaks from 100 to 400 watts, the +/-40 V rails source no current as all the current comes from the +/-80 V rails.
Get AOL Mail for FREE! Manage your email like never before with travel, photo & document views. Personalize your inbox with themes & tabs. You've Got Mail!
A valve RF amplifier (UK and Aus.) or tube amplifier is a device for electrically amplifying the power of an electrical radio frequency signal. Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers during the 1960s and 1970s, initially for receivers and low power stages of ...
A valve amplifier or tube amplifier is a type of electronic amplifier that uses vacuum tubes to increase the amplitude or power of a signal. Low to medium power valve amplifiers for frequencies below the microwaves were largely replaced by solid state amplifiers in the 1960s and 1970s.