enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Width across flats - Wikipedia

   en.wikipedia.org/wiki/Width_across_flats

   A few sizes are close enough to interchange for most purposes, such as 19 mm (close to 3 ⁄ 4 inch (19.05 mm)), 8 mm (close to 5 ⁄ 16 inch (7.94 mm)) and 4 mm (close to 5 ⁄ 32 inch (3.97 mm)). In reality, a wrench with a width across the flats of exactly 15 mm would fit too tightly to use on a bolt with a width across the flats of 15 mm.

3. Bren Ten - Wikipedia

   en.wikipedia.org/wiki/Bren_Ten

   The Bren Ten is a semi-automatic pistol chambered for 10mm Auto that was made by Dornaus & Dixon Enterprises Inc. from 1983 to 1986. While the Bren Ten's design has an appearance similar to the 9×19mm Parabellum CZ-75, it is larger and stronger with several unique design elements that make it a distinctly separate firearm.

4. 10mm Auto - Wikipedia

   en.wikipedia.org/wiki/10mm_Auto

   The 10mm Auto (also known as the 10×25mm, official C.I.P. nomenclature: 10 mm Auto, [7] official SAAMI nomenclature: 10mm Automatic) [8] is a powerful and versatile semi-automatic pistol cartridge introduced in 1983. Its design was adopted and later produced by ammunition manufacturer FFV Norma AB of Åmotfors, Sweden. [12]

5. Drill bit sizes - Wikipedia

   en.wikipedia.org/wiki/Drill_bit_sizes

   From 1.0 through 2.95 mm, sizes are defined as follows, where N is an integer from 10 through 29: N · 0.1 mm; N · 0.1 + 0.05 mm; From 3.0 through 13.9 mm, sizes are defined as follows, where N is an integer from 30 through 139: N · 0.1 mm; From 14.0 through 25.0 mm, sizes are defined as follows, where M is an integer from 14 through 25: M ...

6. Screw thread - Wikipedia

   en.wikipedia.org/wiki/Screw_thread

   Similarly, M10 (10 mm nominal outer diameter) as per ISO 261 has a coarse thread version at 1.5 mm pitch and a fine thread version at 1.25 mm pitch. The term coarse here does not mean lower quality, nor does the term fine imply higher quality. The terms when used in reference to screw thread pitch have nothing to do with the tolerances used ...

7. List of screw and bolt types - Wikipedia

   en.wikipedia.org/wiki/List_of_screw_and_bolt_types

   Square head cap screws up to and including 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 8 inch (3.175 mm) larger than the shank; screws larger than 3 ⁄ 4 inch (19.05 mm) have a head 1 ⁄ 4 inch (6.35 mm) larger than the shank. [9] In 1919, Dyke defined them as screws that are threaded all the way to the head. [10] socket screw