Search results
Results from the WOW.Com Content Network
The tables below provides information on the variation of solubility of different substances (mostly inorganic compounds) in water with temperature, at one atmosphere pressure. Units of solubility are given in grams of substance per 100 millilitres of water (g/(100 mL)), unless shown otherwise. The substances are listed in alphabetical order.
As such water percolates through calcium carbonate rock, the CaCO 3 dissolves according to one of the trends above. When that same water then emerges from the tap, in time it comes into equilibrium with CO 2 levels in the air by outgassing its excess CO 2. The calcium carbonate becomes less soluble as a result, and the excess precipitates as ...
The following chart shows the solubility of various ionic compounds in water at 1 atm pressure and room temperature (approx. 25 °C, 298.15 K). "Soluble" means the ionic compound doesn't precipitate, while "slightly soluble" and "insoluble" mean that a solid will precipitate; "slightly soluble" compounds like calcium sulfate may require heat to precipitate.
The exact value of the CCD depends on the solubility of calcium carbonate which is determined by temperature, pressure and the chemical composition of the water – in particular the amount of dissolved CO 2 in the water. Calcium carbonate is more soluble at lower temperatures and at higher pressures.
Calcite exhibits an unusual characteristic called retrograde solubility: it is less soluble in water as the temperature increases. Calcite is also more soluble at higher pressures. [19] Pure calcite has the composition CaCO 3. However, the calcite in limestone often contains a few percent of magnesium. Calcite in limestone is divided into low ...
As an example of the wide range of solubility of calcium compounds, monocalcium phosphate is very soluble in water, 85% of extracellular calcium is as dicalcium phosphate with a solubility of 2.00 mM, and the hydroxyapatite of bones in an organic matrix is tricalcium phosphate with a solubility of 1000 μM. [59]
The solubility of a specific solute in a specific solvent is generally expressed as the concentration of a saturated solution of the two. [1] Any of the several ways of expressing concentration of solutions can be used, such as the mass, volume, or amount in moles of the solute for a specific mass, volume, or mole amount of the solvent or of the solution.
However, for aqueous solutions, the Henry's law solubility constant for many species goes through a minimum. For most permanent gases, the minimum is below 120 °C. Often, the smaller the gas molecule (and the lower the gas solubility in water), the lower the temperature of the maximum of the Henry's law constant.