enow.com Web Search

Search results

1. Results from the WOW.Com Content Network

2. Wheel sizing - Wikipedia

   en.wikipedia.org/wiki/Wheel_sizing

   The bolt holes are spaced evenly about the bolt hole circle. Wheel studs are the bolts that are on your mounting hub and are used along with lug nuts to attach the wheel to the car. The bolt hole circle is the circle that the center of each bolt aligns with.

3. Bolt circle - Wikipedia

   en.wikipedia.org/wiki/Bolt_circle

   On steering wheels for cars utilizing bolt circles, this usually measures 6×70 mm. [3] Some racing wheels attach to the car via a quick release hub, [4] and this hub then usually has a corresponding bolt circle of 6×70 mm. Example of other less used patterns include: 3×1.75 in (44.45 mm), 5×2.75 in (69.85 mm), 6×74 mm and 6×2.75 in (69.85 mm).

4. Wheel stud - Wikipedia

   en.wikipedia.org/wiki/Wheel_stud

   With lug bolts, on the other hand, the whole hub usually has to be replaced in case of stripped threads in the hub. One motivation for using lug bolts instead of wheel studs and nuts the number of parts that needs to be attached to the wheel hub. Wheel studs and lug nuts consist of two parts, while the lug bolt is a single part.

5. List of drill and tap sizes - Wikipedia

   en.wikipedia.org/wiki/List_of_drill_and_tap_sizes

   Below is a comprehensive drill and tap size chart for all drills and taps: Inch, imperial, and metric, up to 36.5 millimetres (1.44 in) in diameter. In manufactured parts, holes with female screw threads are often needed; they accept male screws to facilitate the building and fastening of a finished assembly.

6. Engineering tolerance - Wikipedia

   en.wikipedia.org/wiki/Engineering_tolerance

   The standard (size) tolerances are divided into two categories: hole and shaft. They are labelled with a letter (capitals for holes and lowercase for shafts) and a number. For example: H7 (hole, tapped hole, or nut) and h7 (shaft or bolt). H7/h6 is a very common standard tolerance which gives a tight fit.

7. Clevis fastener - Wikipedia

   en.wikipedia.org/wiki/Clevis_fastener

   The clevis is a U-shaped piece that has holes at the end of the prongs to accept the clevis pin. The clevis pin is similar to a bolt, but is either partially threaded or unthreaded with a cross-hole for a split pin. A tang is a piece that is sometimes fitted in the space within the clevis and is held in place by the clevis pin.